Abstract:The workpiece dynamics are an important factor in the planning of machining strategy. Usually, the structural dynamic parameters of workpiece are obtained by experimental modal analysis (EMA). However, the dynamics of thin-walled workpiece are varying due to material removal and tool-workpiece coupling. Operational modal analysis (OMA) provides a route to estimate the structural dynamic parameters during operation, but the input excitation of milling system is mainly periodic milling force, which violates the premise of OMA. In this paper, an output-only modal identification method for the dynamic parameters of thin-walled workpiece is proposed. The milling force is analyzed and the analysis results show the milling force contains white noise for OMA. However, strong harmonic components in milling force seriously interfere the identification of dynamic parameters. To remove the harmonic components in response signal, a revised least-squares (LS) method is proposed to fit harmonics with multiple fundamental frequencies. After the harmonic removal, OMA is conducted in frequency domain using the poly-reference least squares complex frequency (p-LSCF) method based on positive power spectral density (PSD). To verify the feasibility of the proposed method, the simulation case is conducted by exciting a 3-degree of freedom structure using measured milling force signal, and the results show a good agreement with the theoretical values both in frequencies and damping ratios. Furthermore, a series of milling tests under different cutting parameters are conducted on a thin-walled workpiece, where thin-film sensors are adopted to measure the structural response. The results show the method can be successfully applied to extract the workpiece dynamic parameters. Compared with results of EMA, the structural frequencies increase slightly, while the damping ratios show a large promotion due to the process damping.

Identification of modal parameters of response signals in the white noise excitation with harmonics based on cepstrum

An Extended Modal Approach for Modal Parameter Identification of Structure under the Existence of Harmonic Excitations

Operational Modal Analysis under Harmonic Excitation Using Ramanujan Subspace Projection and Stochastic Subspace Identification

Operational modal analysis in the presence of harmonic excitation

A method to distinguish harmonic frequencies and remove the harmonic effect in operational modal analysis of rotating structures

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

Identification Method of Modal Parameters of Machine Tools under Periodic Cutting Excitation

Identification of modal parameters using cross-correlation technique and wavelet transform

Wavelet based modal identification using nonstationary response measurements

Vibration based operational modal analysis of rotor systems

Operational modal analysis based dynamic parameters identification in milling of thin-walled workpiece

Modal Parameter Identification of Jacket-Type Offshore Wind Turbines Under Operating Conditions

Model-free Identification of Multiple Periodic Excitations and Detection of Structural Anomaly Using Noisy Response Measurements

Output-only Modal Identification Based on Hierarchical Hough Transform

Fully Automated Operational Modal Identification Based on Scale-Space Peak Picking Algorithm and Power Spectral Density Estimation

Low Frequency Oscillation Modal Parameter Identification Based on Natural Excitation Technique

Damping identification using weighted fitting of Frequency-response-function (WFF) method

Output-only Modal Parameter Identification for Force-Embedded Acceleration Data in the Presence of Harmonic and White Noise Excitations

Response signals-based structural modal parameter identification

Output-based modal parameters identification of a three dimensional structure

Application of Natural Excitation Technique in the Structures under Time-delay-correlative White Noise Excitations