Abstract:Operational modal analysis (OMA), or output-only modal analysis, has been widely conducted especially when excitation applied on a structure is unknown or difficult to measure. Discrete cross-correlation functions and cross-power spectra between a reference data series and measured response data series are bases for OMA to identify modal properties of a structure. Such functions and spectra can be efficiently transformed from each other using the discrete Fourier transform (DFT) and inverse DFT (IDFT) based on the cross-correlation theorem. However, a direct application of the theorem and transforms, including the DFT and IDFT, can yield physically erroneous results due to periodic extension of the DFT on a function of a finite length to be transformed, which is false most of the time. Padding zero series to ends of data series before applying the theorem and transforms can reduce the errors, but the results are still physically erroneous. A new methodology is developed in this work to calculate discrete cross-correlation functions of non-negative time delays and associated cross-power spectra, referred to as half spectra, for OMA. The methodology can be extended to cross-correlation functions of any time delays and associated cross-power spectra, referred to as full spectra. The new methodology is computationally efficient due to use of the transforms. Data series are properly processed to avoid the errors caused by the periodic extension, and the resulting cross-correlation functions and associated cross-power spectra perfectly comply with their definitions. A coherence function, a convergence function, and a convergence index are introduced to evaluate qualities of measured cross-correlation functions and associated cross-power spectra. The new methodology was numerically and experimentally applied to an ideal two-degree-of-freedom (2-DOF) mass–spring–damper system and a damaged aluminum beam, respectively, and OMA was conducted using half spectra to estimate their natural frequencies, damping ratios, and mode shapes. Natural frequencies, damping ratios, and mode shapes of the 2-DOF system obtained from OMA agree well with theoretical ones from complex modal analysis; natural frequencies, damping ratios, and mode shapes of the beam from OMA agreed well with those from experimental modal analysis.

Operational modal analysis in the presence of harmonic excitation

A method to distinguish harmonic frequencies and remove the harmonic effect in operational modal analysis of rotating structures

An Extended Modal Approach for Modal Parameter Identification of Structure under the Existence of Harmonic Excitations

Identification of modal parameters of response signals in the white noise excitation with harmonics based on cepstrum

Operational Modal Analysis under Harmonic Excitation Using Ramanujan Subspace Projection and Stochastic Subspace Identification

Vibration based operational modal analysis of rotor systems

Accurate and efficient calculation of discrete correlation functions and power spectra

Application of Natural Excitation Technique in the Structures under Time-delay-correlative White Noise Excitations

Modal identification with uncertainty quantification of large‐scale civil structures via a hybrid operation modal analysis framework

A comparative study of dynamic analysis methods for structural topology optimization under harmonic force excitations

Non-stationary signal decomposition approach for harmonic responses detection in operational modal analysis

Operational modal analysis based dynamic parameters identification in milling of thin-walled workpiece

Operational modal analysis of under-determined system based on Bayesian CP decomposition

Detection and correction of synchronization-induced errors in operational modal analysis

Operational Modal Analysis of Transformer Windings

Operational modal analysis using lifted continuously scanning laser Doppler vibrometer measurements and its application to baseline-free structural damage identification

Improved Automatic Operational Modal Analysis Method and Application to Large-Scale Bridges

Operational modal analysis of a machine-tool structure during machining operations

Modal Parameter Identification of Jacket-Type Offshore Wind Turbines Under Operating Conditions

Operational Modal Analysis of a Rotating Structure Subject to Random Excitation Using a Tracking Continuously Scanning Laser Doppler Vibrometer via an Improved Demodulation Method

Unity method for EMA and OMA in the frequency domain