Abstract:Deformation twinning is a phenomenon that causes local shear strain concentrations, with the material either experiencing elongation (and thus a tensile stress) or contraction (compressive stress) along the stress directions. Thus, in order to gauge the performance of the alloy better, it is imperative to predict the activation of twinning systems successfully. The present study investigates the effects of deformation by cold-rolling on the {332}<113> and {112}<111> twin variant activation in a Ti-30Nb-12Zr-5Ta-2Sn-1.25Fe (wt.%) (TNZTSF) alloy. The Ti-30Nb-12Zr-5Ta-2Sn-1.25Fe (wt.%) alloy was synthesized in a cold crucible induction levitation furnace, under an argon-controlled atmosphere, using high-purity elemental components. The TNZTSF alloy was cold-deformed by rolling, in one single step, with a total deformation degree (thickness reduction) of ε ≈ 1% (CR 1), ε ≈ 3% (CR 3), and ε ≈ 15% (CR 15). The microstructural investigations were carried out with the SEM-EBSD technique in order to determine the grain morphology, grain-size distribution, crystallographic orientation, accumulated strain-stress fields and Schmid Factor (SF) analysis, all necessary to identify the active twin variants. The EBSD data were processed using an MTEX Toolbox ver. 5.7.0 software package. The results indicated that the TNZTSF alloy’s initial microstructure consists of a homogeneous β-Ti single phase that exhibits equiaxed polyhedral grains and an average grain-size close to 71 μm. It was shown that even starting with a 1% total deformation degree, the microstructure shows the presence of the {332}<113> twinning ((233)[3¯11] active twin variant; Schmit factor SF = −0.487); at a 3% total deformation degree, one can notice the presence of primary and secondary twin variants within the same grain belonging to the same {332}<113> twinning system ((323¯)[13¯1¯] primary twin variant—SF = −0.460; (233¯)[3¯11¯] secondary twin variant—SF = −0.451), while, at a 15% total deformation degree, besides the {332}<113> twinning system, one can notice the activation of the {112}<111> twinning system ((11¯2)[1¯11] active twin variant—SF = −0.440). This study shows the {332}<113> and {112}<111> twinning variant activation during cold-deformation by rolling in the case of a Ti-30Nb-12Zr-5Ta-2Sn-1.25Fe (wt.%) (TNZTSF) alloy.

Deformation Twinning Caused by Warm Rolling and Secondary Recrystallizaion in Twin-Roll Strip Casting Fe81ga19 Alloy

The Influence of Warm Rolling Reduction on Microstructure Evolution, Tensile Deformation Mechanism and Mechanical Properties of an Fe-30Mn-4Si-2Al TRIP/TWIP Steel

Introducing Equiaxed Grains and Texture into Ni-Mn-Ga Alloys by Hot Extrusion for Superplasticity

The Effect of Heat Treatments on the Microstructural Evolution of Twin-Roll-Cast Al-Fe-Si Alloys

Recrystallization Behavior and Mechanical Properties of Az31b Alloy During the Hot-Rolling Process

A combined EBSD and machine learning study of predicting deformation twinning in BCC Fe 81 Ga 19 alloy

Twinning Behavior of a Strongly Basal Textured AZ31 Mg Alloy During Warm Rolling

Texture evolution and twinnability prediction of the most compliant orientation in GH3536 superalloy during cold rolling

Deformation substructural evolution in transformation-induced plasticity high-entropy alloy during cold rolling

Novel deformation twinning system in a cold rolled high-strength metastable- Ti-5Al-5V-5Mo-3Cr-0.5Fe alloy

{332}<113> and {112}<111> Twin Variant Activation during Cold-Rolling of a Ti-Nb-Zr-Ta-Sn-Fe Alloy

Unique transition of yielding mechanism and unexpected activation of deformation twinning in ultrafine grained Fe-31Mn-3Al-3Si alloy

Deformation Twinning Behaviors of the Low Stacking Fault Energy High-Entropy Alloy: an In-Situ TEM Study

Transition of twinning behavior in CoCrFeMnNi high entropy alloy with grain refinement

Secondary recrystallization induced by composite precipitates in magnetostrictive Fe-Ga alloy thin sheet

Twinning Engineering of a CoCrFeMnNi High-Entropy Alloy

Multiple deformation mechanisms induced by pre-twinning in CoCrFeNi high entropy alloy

Effect of Local Stresses of Primary Twinning on Double Twinning, Twin Intersection and Their Competition

Twinning and dynamic recrystallization behaviors during inchoate deformation of pre-twinned AZ31 Mg alloy sheet at elevated temperatures

Multiscale crystal plasticity finite element simulations of the deformation inhomogeneity of TiBw/TA15 composites with network-structured during hot rolling

Effect of High-Temperature Deformation Twinning on the Work Hardening Behavior of Fe-38Mn Alloy during Hot Shear-Compression Deformation