Abstract:At present, there are several kinds of broadband antireflection coatings (ARCs). For the flat multilayer ARC, it usually contains double, triple, or up to 4 layers. It has been demonstrated that the performance of a single layer coating is not good enough across the desired spectral range. Multiple layer ARCs have much better performance for broadband solar cells (SCs). When inspecting the antireflection structure of Cu2ZnSnS4 solar cells (CZTSSCs), it is shown that the transparent conductive oxide (TCO) of traditional CZTSSCs does not have an satisfactory antireflective performance. This paper aims to investigate a way to increase the incident light transmitted into CZTSSCs, and thus improving the efficiency of solar cells by studying the use of the antireflective effect of a TCO film. It introduces a new type of TCO film with better antireflective properties across a wide wavelength range. An SiO2/ZnO antireflective TCO (ATCO) is designed under AM1.5 illumination. In order to measure the antireflective effect over the 300–800 nm wavelength range, an effective average reflectance method (EAR) is introduced. Considering the effect of the refractive index dispersion and the coupling of the TCO or ATCO films with the active layer, in this paper we use a multi-dimensional transfer matrix to optimize the thickness of each key layer to accurately confirm the best antireflective effect. In addition, the optimized TCO film and the optimized ATCO film in CZTSSCs are compared and analyzed by means of EAR. The result shows, through the comparison of the antireflection between conventional TCO CZTSSCs and ATCO CZTSSCs, that there are considerable differences in final optimal reflectivity between TCO layer and ATCO film. For the conventional CZTSSC, the optimal effective average reflectance of TCO layer is 5.6%, and the lowest reflectivity in the waveband from 400 nm to 500 nm is 6.9%. In addition, the corresponding values obtained in the new ATCO CZTSSC are 3.8% and 1.6% respectively. These apparent changes in reflectivity are appealing in that the new ATCO films can effectively reduce light loss and improve the efficiency of photovoltaic conversion.

Efficiency improvement of CIGS solar cells using RF sputtered TCO/Ag/TCO thin-film as prospective buffer layer

Improvement of the CIGS solar cell performance: structure based on a ZnS buffer layer

Impact of graded CIGS absorber layer on Cd-free CIGS thin-film solar cell performance: Numerical optimization

Numerical Simulation of Copper Indium Gallium Diselenide Solar Cell with Ultra-Thin BaSi2 Back Surface Field Layer Using the Non-Toxic In2Se3 Buffer Layer

Thin oxide buffer layers for avoiding leaks in CIGS solar cells; a theoretical analysis

Investigating the potential of cobalt-doped zinc oxide (Zn1-xCoxOδ) as a buffer layer for CZTS thin-film solar cells

Transparent Conductive Oxide Film with Antireflective Properties for Cu<sub>2</sub>ZnSnS<sub>4</sub> Solar Cells

Fabrication of ZnO/CuBr1-x I x microstructural transparent solar cells with buffer layer

Design and numerical analysis of CIGS-based solar cell with V2O5 as the BSF layer to enhance photovoltaic performance

Ultrathin chromium oxide buffer layer by reactive thermal deposition for high-performance semitransparent perovskite solar cells

Investigation on the Performance of CIGS/TiO2 Heterojunction Using SCAPS Software for Highly Efficient Solar Cells

Electrical barriers and their elimination by tuning (Zn,Mg)O composition in Cu(In,Ga)S2: Systematic approach to achieve over 14% power conversion efficiency

CHTS/Zn2P3-based solar cells with enhanced efficiency through ETL engineering: A numerical study

Influence of Sulfur Content in Zn(O,S) Buffer Layer onto Copper Indium Gallium Sulfur-Based Solar Cells Through Surface Engineering at ZnO1−xSx/CIGS Interface

Atomic-Scale Interface Modification Improves the Performance of Cu(In1- xGax)Se2/Zn(O,S) Heterojunction Solar Cells

A qualitative Design and optimization of CIGS-based Solar Cells with Sn2S3 Back Surface Field: A plan for achieving 21.83 % efficiency

Scalable CIGS Solar Cells Employing a New Device Design of Nontoxic Buffer Layer and Microgrid Electrode

High-Efficiency Cu(In,Ga)Se₂ Thin Film Solar Cells Using ZnS and CdS Buffer Layers

Improvement of the Electrical Properties of a Cu(In,Ga)Se₂ Solar Cell Based on a ZnS Buffer Layer from Radio Frequency Magnetron Sputtering

Performance enhancement of CIGS-based solar cells by incorporating an ultrathin BaSi2 BSF layer

Performance Improvement of Solution-Processed CdS/CdTe Solar Cells with a Thin Compact TiO2 Buffer Layer