Abstract:Terrain Awareness and Warning Systems (TAWS) are on-board systems that alert crews to imminent Controlled Flight into Terrain (CFIT). Originally required by the FAA in 1974 for all Part 121 aircraft, this technology has advanced to include GPS data, terrain and obstacle databases, and sophisticated flight deck displays to provide increasingly accurate and timely alerts. TAWS equipment is capable of generating a set of audible and visual alerts based on the most likely situations which lead to a high risk of CFIT. These include excessive descent rates, excessive vertical deviation from an Instrument Landing System (ILS) glideslope, proximity to terrain with landing gears up, and descent immediately following a takeoff. Although the incident rate of CFIT has been greatly reduced over the past few decades, areas of risk still exist, typically near small airports surrounded by mountainous terrain. Risk also remains due to economic factors. The high cost of hardware and software upgrades delays the universal adoption of the most advanced TAWS equipment. Older equipment is much more likely to generate nuisance alerts-warnings to the crew during periods of low CFIT risk. These nuisance alerts desensitize crews to TAWS, leading to situations where crews may ignore or not fully respond to alerts that indicate real danger. Separately, FAA NextGen efforts are driving major redesigns of airspaces and procedures across the country. The primary factors in redesign focus on minimizing the costs associated with delay and fuel burn; however, these redesigns must also ensure that changes do not introduce new CFIT risks. Current practices depend on incomplete evidence to determine that risk has not increased. The continued elimination of remaining CFIT risk, along with the possibility of introducing new risk during redesign, necessitate a comprehensive TAWS model to understand current and potential hazards. Without a TAWS model to provide rapid feedback during simulated design changes, several months may pass before observing that a design change has increased CFIT risk. In this paper, we describe the construction and validation of a standards-based TAWS model to capture the behavior of a variety of equipment. This paper also describes a process for measuring the effect of procedure redesign on TAWS alert rates. Finally, we include a case study of analyzing approaches into the airport at Eagle, CO—the airport with the highest TAWS alert rates in the country. In this case study, we find that equipment upgrades would eliminate nuisance alerts for aircraft using currently published approach procedures.

Development and operation of the Traffic Alert and Collision Avoidance System (TCAS)

STCA, TCAS, airproxes and collision risk

Exploration of new algorithms for airborne collision detection and avoidance to meet NextGen capabilities

High-level modeling and analysis of the traffic alert and collision avoidance system (TCAS)

Modeling terrain awareness and warning systems for airspace and procedure design

Active Fault Tolerant Control of Adaptive Cruise Control System Considering Vehicle-Borne Millimeter Wave Radar Sensor Failure

ISAC-Assisted Collision Avoidance Mechanism for Vehicle-to-Infrastructure Systems

Air Traffic Control Command Monitoring System Based on Information Integration

On the Feasibility of Exploiting Traffic Collision Avoidance System Vulnerabilities

Information-integration Based Air Traffic Control Command Monitoring System- ATCCMS

Understanding Realistic Attacks on Airborne Collision Avoidance Systems

A Survey of Recent Developments in Collision Avoidance, Collision Warning and Inter-Vehicle Communication Systems

Collision Avoidance Capabilities in High-Density Airspace Using the Universal Access Transceiver ADS-B Messages

The Use of a Weather Radar as a Terrain Warning System

Collision Avoidance of Two Autonomous Quadcopters

Safe4RAIL-2: Advanced architectures and components for the Next-Generation Train Control and Monitoring System

A Taxonomy for Aerospace Collision Avoidance with Implications for Automation in Space Traffic Management

Toward collision-free trajectory for autonomous and pilot-controlled unmanned aerial vehicles

A Traffic Control Framework for Uncrewed Aircraft Systems

Infrastructure Development for Ground-Based Separation Assurance with Optional Automation

Flight-Test of a Tactile Situational Awareness System in a Land-based Deck Landing Task