Abstract:Terrain Awareness and Warning Systems (TAWS) are on-board systems that alert crews to imminent Controlled Flight into Terrain (CFIT). Originally required by the FAA in 1974 for all Part 121 aircraft, this technology has advanced to include GPS data, terrain and obstacle databases, and sophisticated flight deck displays to provide increasingly accurate and timely alerts. TAWS equipment is capable of generating a set of audible and visual alerts based on the most likely situations which lead to a high risk of CFIT. These include excessive descent rates, excessive vertical deviation from an Instrument Landing System (ILS) glideslope, proximity to terrain with landing gears up, and descent immediately following a takeoff. Although the incident rate of CFIT has been greatly reduced over the past few decades, areas of risk still exist, typically near small airports surrounded by mountainous terrain. Risk also remains due to economic factors. The high cost of hardware and software upgrades delays the universal adoption of the most advanced TAWS equipment. Older equipment is much more likely to generate nuisance alerts-warnings to the crew during periods of low CFIT risk. These nuisance alerts desensitize crews to TAWS, leading to situations where crews may ignore or not fully respond to alerts that indicate real danger. Separately, FAA NextGen efforts are driving major redesigns of airspaces and procedures across the country. The primary factors in redesign focus on minimizing the costs associated with delay and fuel burn; however, these redesigns must also ensure that changes do not introduce new CFIT risks. Current practices depend on incomplete evidence to determine that risk has not increased. The continued elimination of remaining CFIT risk, along with the possibility of introducing new risk during redesign, necessitate a comprehensive TAWS model to understand current and potential hazards. Without a TAWS model to provide rapid feedback during simulated design changes, several months may pass before observing that a design change has increased CFIT risk. In this paper, we describe the construction and validation of a standards-based TAWS model to capture the behavior of a variety of equipment. This paper also describes a process for measuring the effect of procedure redesign on TAWS alert rates. Finally, we include a case study of analyzing approaches into the airport at Eagle, CO—the airport with the highest TAWS alert rates in the country. In this case study, we find that equipment upgrades would eliminate nuisance alerts for aircraft using currently published approach procedures.

STCA, TCAS, airproxes and collision risk

Development and operation of the Traffic Alert and Collision Avoidance System (TCAS)

Understanding Realistic Attacks on Airborne Collision Avoidance Systems

Effects of Display Format of Cockpit Air Traffic Information on Conflict Detection Performance

Exploration of new algorithms for airborne collision detection and avoidance to meet NextGen capabilities

On the Feasibility of Exploiting Traffic Collision Avoidance System Vulnerabilities

High-level modeling and analysis of the traffic alert and collision avoidance system (TCAS)

Toward collision-free trajectory for autonomous and pilot-controlled unmanned aerial vehicles

Effects of air traffic geometry on pilots' conflict detection with cockpit display of traffic information

A Survey of Recent Developments in Collision Avoidance, Collision Warning and Inter-Vehicle Communication Systems

A Taxonomy for Aerospace Collision Avoidance with Implications for Automation in Space Traffic Management

Cognitive demands of collision avoidance in simulated ship control

Analysis and Prevention of MCAS-Induced Crashes

Human Factors Analysis of Air Traffic Safety Based on HFACS-BN Model

Formally Verified Next-Generation Airborne Collision Avoidance Games in ACAS X

Collision Avoidance of Two Autonomous Quadcopters

Bayesian network model of aviation safety: Impact of new communication technologies on mid-air collisions

Modeling terrain awareness and warning systems for airspace and procedure design

A Systematic Approach for Collision Risk Analysis Based on Ais Data

ISAC-Assisted Collision Avoidance Mechanism for Vehicle-to-Infrastructure Systems

Air Traffic Control Command Monitoring System Based on Information Integration