Abstract:Phase change materials (PCMs) are materials that can store large amounts of heat during their phase transition from solid to liquid without a significant increase in temperature. While going from liquid to solid this heat is again released. As such, these materials can play an important role in future energy-efficient buildings. If applied in facades as part of a thermal buffer strategy, e.g., capturing and temporarily storing solar energy in so-called Trombe walls, the PCMs are exposed to high solar radiation intensities, which may easily lead to issues of overheating. This paper therefore investigates the melting process of PCM and arrives at potential solutions for countering this overheating phenomenon. This study uses the simulation program Comsol to investigate the heat transfer through, melting of and fluid flow inside a block of PCM (3 × 20 cm2) with a melting temperature of around 25 °C. The density, specific heat and dynamic viscosity of the PCM are modeled as a temperature dependent variable. The latent heat of the PCM is modeled as part of the specific heat. One side of the block of PCM is exposed to a heat flux of 300 W/m2. The simulations show that once part of the PCM has melted convection arises transporting heat from the bottom of the block to its top. As a result, the top heats up faster than the bottom speeding up the melting process there. Furthermore, in high columns of PCM a large temperature gradient may arise due to this phenomenon. Segmenting a large volume of PCM into smaller volumes in height limits this convection thereby reducing the temperature gradient along the height of the block. Moreover, using PCMs with different melting temperature along the height of a block of PCM allows for controlling the speed with which a certain part of the PCM block starts melting. Segmenting the block of PCM using PCMs with different melting temperature along its height was found to give the most promising results for minimizing this overheating effect. Selecting the optimal phase change temperatures however is critical in that case.

The effect of triangular phase change material rods in the air conditioning duct on the amount of energy required for a residential building

The effect of using tubes filled with phase change materials in the air conditioning system of a residential building

Numerical Simulation on the Thermal Performance of a PCM-containing Ventilation System with a Continuous Change in Inlet Air Temperature

Experimental Study on the Demand Shifting Effects of PCM Integrated Air-Conditioning Duct

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Melting Performance Enhancement of Phase Change Material with Magnetic Particles under Rotating Magnetic Field

Energy and economic analysis of a building air-conditioner with a phase change material (PCM)

Evaluation of Phase Change Materials for Pre-Cooling of Supply Air into Air Conditioning Systems in Extremely Hot Climates

New structure for better thermal resistance of building with phase change material: Response to milder thermal change than common walls

Analysis of the Properties and Thermal Behavior of Low-Temperature Phase Change Materials (PCMs) That Can Be Applied in Heating and Ventilation Systems

Numerical Study on the Effect of Incorporating Phase Change Materials in a Wall

Energy reduction of building air-conditioner with phase change material in Thailand

Enhancing the Air Conditioning Unit Performance via Energy Storage of Different Inorganic Phase Change Materials with Hybrid Nanoparticles

Computational study on transient thermal performance enhancement of phase change materials in triplex tube heat exchanger through novel annular-finned configurations

Experimental Investigation and Numerical Modeling of Room Temperature Control in Buildings by the Implementation of Phase Change Material in the Roof

Exploring the Potential of Phase Change Material for Thermal Energy Storage in Building Envelopes

Temperature Control in (Translucent) Phase Change Materials Applied in Facades: A Numerical Study

Energy management of residential buildings using innovative passive techniques

Parametric Analysis of the Phase Change Material Wall Combining with Micro-Channel Heat Pipe and Sky Radiative Cooling Technology

A review of radiant heating and cooling systems incorporating phase change materials

Impact of phase change materials and brick thickness on thermal comfort in free-floating mode