Abstract:Phase change materials (PCMs) exploit their cyclic phase change (solidification and melting) to enable latent heat storage. While incorporating them in thermally activated building systems can potentially enhance energy savings and thermal comfort, they can introduce significant challenges to the building energy management system. This work first reports the result of small-scale side-by-side experiments on two thermally active cuboids with and without BioPCMs at different supply water and PCM melting temperatures, as well as irradiance levels. Next, a dynamic model is developed in TRNSYS v18.05 for a typical design of an office space under hot desert climate conditions. The model is then integrated into a multi-objective optimization routine using NSGA-II algorithms to identify the optimal characteristic cooling curves, melting temperatures, and PCM thicknesses that simultaneously minimize energy consumption and maximize the percentage of comfortable hours. The experimental observations of the PCM-integrated cuboid highlighted energy savings between 80.45 and 84.56 %, compared to the reference cuboid, at nearly the same levels of indoor temperatures. The PCM panels reduced the cooling capacity of the radiant floor but also dampened air temperature variations by up to 83.17 %. Besides, higher solar irradiance levels, encountered in desert areas, were found to enhance the cooling capacity by up to 46.8 %. The Pareto solutions highlighted the possibility of achieving acceptable unmet hours of 3.16 % using PCMs and without the need for an assisting air system, compared to 14.1 % without PCMs. Besides, at the same unmet hours of the reference system, the PCMs reduced the total energy consumption and the peak cooling power by 9.75 and 41.2 %, which translates into substantial operation and capital investments, respectively. Moreover, the study demonstrated by example the importance of calibrating the commonly used cooling curves of thermally active buildings when planning for PCM integration.

The effect of using tubes filled with phase change materials in the air conditioning system of a residential building

The effect of triangular phase change material rods in the air conditioning duct on the amount of energy required for a residential building

Evaluation of Phase Change Materials for Pre-Cooling of Supply Air into Air Conditioning Systems in Extremely Hot Climates

Analysis of the Properties and Thermal Behavior of Low-Temperature Phase Change Materials (PCMs) That Can Be Applied in Heating and Ventilation Systems

Enhancing the Air Conditioning Unit Performance via Energy Storage of Different Inorganic Phase Change Materials with Hybrid Nanoparticles

Experimental and Numerical Performance Analysis of an Active Cooling Wall Module Equipped with Micro-encapsulated Phase Change Material

Experimental Study on the Demand Shifting Effects of PCM Integrated Air-Conditioning Duct

Experimental investigation of PCM transient performance in free cooling of the fresh air of air conditioning systems

Influence of coupling air conditioner with hybrid PCMs on building interior conditions and consumed power: Experimental investigation

Experimental research on the use of phase change materials in perforated brick rooms for cooling storage

Integrating phase change material in building envelopes combined with the earth-to-air heat exchanger for indoor thermal environment regulation

Power saving in a central air conditioning system by using multiple PCMs integrated with fresh air path

Energy and economic analysis of a building air-conditioner with a phase change material (PCM)

Experimental study of the thermal and energy conservation characteristics of combined phase change material (PCM) room in summer

Enhancing energy efficiency of air conditioning system through optimization of PCM-based cold energy storage tank: A data center case study

Impact of phase change materials and brick thickness on thermal comfort in free-floating mode

A review of radiant heating and cooling systems incorporating phase change materials

Numerical Study on the Effect of Incorporating Phase Change Materials in a Wall

Optimizing the characteristic cooling curves of PCM-integrated thermally active buildings: Experimental and numerical investigations

The effect of operation modes on the thermal performance of a novel multi-tubular phase change material-filled earth-air heat exchanger

An innovative modified calcium chloride hexahydrate–based composite phase change material for thermal energy storage and indoor temperature regulation