Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

Cold rolling force model of nuclear power zirconium alloy based on Particle Swarm Optimization

The cold rolling load distribution of the nuclear power zirconium alloy based on the self-adaptive particle swarm optimization algorithm

Influence of rolling force optimization on thickness accuracy of 20-high cold-rolling mill of silicon steel

Numerical simulation analysis of the rolling process based on the particle swarm hybrid algorithm

Adaptive learning prediction on rolling force in the process of reversible cold rolling mill

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Analysis of Rolling Force Model in Cold Rolling Mill

Analysis of Feasibility for Rolling Force Model Optimization of Hot Strip Mill of Jinan Iron & Steel Group Corporation

Effects of Rolling Speed and Reduction on Rolling Simulation Results of Monolithic Fuel Plates

Numerical Simulation Research on Rolling Process of Monolithic Nuclear Fuel Plate

Zircaloy Plate Rolling Simulation with an Effective Strain-Rate-Dependent Stress-Updating Algorithm

The Optimal Design for the Production of Hot Rolled Strip with “tight Oxide Scale” by Using Multi-objective Optimization

Comprehensive Parameters Adaption of Rolling Force Model Based on Objective Function in Tandem Cold Mill

Deformation resistance prediction of tandem cold rolling based on grey wolf optimization and support vector regression

On the Optimization of a Rolling-Force Model for a Hot Strip Finishing Line

Research on the analytical model of rolling force for TiAl alloy pack rolling

Prediction of deformation characteristics and critical velocities during cold-spray: A new 3D model

Rolling Force Prediction for Strip Casting Using Theoretical Model and Artificial Intelligence

The Collapse Deformation Prediction Model of Wide 7075 Al-Alloy Intermediate Slabs Based on Particle Swarm Optimization and Support Vector Regression During the Hot Rolling Process

Research progress and intelligent trend of accurate modeling of rolling force in metal sheet

Research on the Prediction of Roll Wear in a Strip Mill