Abstract:Innovations in lithium-ion batteries rely crucially on the availability of advanced characterization techniques. High-resolution chemical imaging of low-Z elements e.g., lithium (Li) is often difficult in many conventional chemical analysis techniques such as Energy-Dispersive X-ray Spectroscopy. High-resolution Secondary Ion Mass Spectrometry (SIMS) imaging is a well-known technique for the analysis of all elements including isotopes. For this reason, SIMS imaging is used in numerous studies related to Li-ion battery research. While direct imaging of Li in post-mortem battery components is helpful to understand parts of the degradation mechanisms, a complete dynamic view of the evolution of the Li distribution at high resolution during operation (‘ operando ’) of batteries is required to fully understand the local interfacial processes, charge transport characteristics and the degradation mechanisms. A few reports presenting operando Time-of-Flight SIMS imaging of batteries have recently been published [1], but the lateral resolution demonstrated in these reports is not adequate to study local processes that occur at nanoscale. In order to demonstrate operando SIMS chemical imaging with sub-20 nm lateral resolution, we developed a novel operando methodology suitable for Focused Ion Beam (FIB)-SIMS imaging and analysis (see Fig. 1). An in-house designed magnetic-sector mass spectrometer [2] attached to a ThermoFisher SCIOS Ga + FIB is used for SIMS chemical imaging. A special operando sample holder was designed to enable electrochemical cycling of batteries within the FIB-SIMS instrument. The micromanipulator inside the FIB (typically used for preparing thin lamellae for Transmission Electron Microscopy) is used to contact one of the battery electrodes through the operando sample holder and complete the electrical circuit. An external potentiostat is then connected to the instrument to drive the charging/discharging of batteries. The proof-of-concept experiments were performed using Li|Li 7 La 3 Zr 2 O 12 |Li symmetric half-cells. Galvanostatic cycling was performed in-situ inside the FIB-SIMS instrument until the sample failed. SIMS chemical mapping revealed a redistribution of Li during cycling. Lithium rich phases appeared during cycling which likely percolated through grain-boundaries and pores of the solid electrolyte causing a short-circuit failure. These results validate our methodology for operando analysis of Li-ion batteries with the possibility to obtain SIMS chemical images with sub-20 nm lateral resolution [3]. This work was funded by the Luxembourg National Research Fund (FNR) through the grant INTER/MERA/20/13992061 (INTERBATT). [1] Y. Yamagishi, et al., J. Phys. Chem. Lett. 2021, 12, 19, 4623–4627 [2] O. De Castro, et al., Analytical Chemistry, 2022, 94, 30, 10754–10763. [3] L. Cressa, et al., Analytical Chemistry, 2023, under review. Figure 1

External microbeam PIGE study of Li and F distribution in PVdF/HFP electrolyte gel polymer for lithium battery application

Lithium ion conducting gels containing porous PVDF-HFP matrix filled with crosslinked PEG

Effects of PDMS with Polyether Side Chains on the Fluoropolymer Based Gel Lithium Electrolytes

Preparation and Properties of Gel Membrane Containing Porous PVDF-HFP Matrix and Cross-Linked PEG for Lithium Ion Conduction

Preparation And Characterization Of Gamma-Ray Irradiated Gel Polymer Electrolyte For Lithium-Ion Polymer Batteries

Dehydrofluorination Process of Poly(vinylidene difluoride) PVdF-Based Gel Polymer Electrolytes and Its Effect on Lithium-Sulfur Batteries

Crystallinity and morphology of PVdF–HFP-based gel electrolytes

A strong nucleophilic fluorination agent to achieve highly stable in-situ 3D cross-linked gel polymer electrolyte for lithium-ion batteries

Electrochemical and X-ray Photospectroscopy Studies of Polytetrafluoroethylene and Polyvinylidene Fluoride in Li/C Batteries

Preparation and Properties of Gel‐filled PVDF Separators for Lithium Ion Cells

Towards Operando Secondary Ion Mass Spectrometry Imaging of Lithium Redistribution in Solid-State Lithium-Ion Batteries: Correlation of Structural, Chemical and Electrochemical Characteristics

Enhanced Imaging of Lithium Ion Battery Electrode Materials

Investigation on PVDF-HFP microporous membranes prepared by TIPS process and their application as polymer electrolytes for lithium ion batteries

A Gel Polymer Electrolyte Based on PVDF-HFP Modified Double Polymer Matrices Via Ultraviolet Polymerization for Lithium-Sulfur Batteries

Polyvinyl Formal Based Gel Polymer Electrolyte Prepared Using Initiator Free In-Situ Thermal Polymerization Method

Fast sample preparation for organo(fluoro)phosphate quantification approaches in lithium ion battery electrolytes by means of gas chromatographic techniques

FTIR and rheological studies of PMMA-based nano-dispersed gel polymer electrolytes incorporated with LiBF4 and SiO2

Microstructure formation of lithium-ion battery electrodes during drying – An ex-situ study using cryogenic broad ion beam slope-cutting and scanning electron microscopy (Cryo-BIB-SEM)

UV-curable PVdF-HFP-based gel electrolytes with semi-interpenetrating polymer network for dendrite-free Lithium metal batteries

A Study on PVDF-HFP Gel Polymer Electrolyte for Lithium-Ion Batteries

Lift-Out Specimen Preparation and Multiscale Correlative Investigation of Li-Ion Battery Electrodes Using Focused Ion Beam-Secondary Ion Mass Spectrometry Platforms