Abstract:Abstract Currently, many different aircraft engine types exist. They have a wide range of operating conditions: the flight speed can vary from zero to hypersonic values, the flight altitude from near-earth conditions to space flights. During the flight, loads are not kept constant. Engines have significant dynamic overloads, temperature and pressure differences, can operate in conditions of high humidity or dust, as well as in various aggressive environments. The development of aviation and rocket engine building is associated with a continuous increase in the working thermodynamical cycle parameters. Further improvement of gas turbine engines (GTE) can be carried out in two directions. The first is using new advanced engine designs based on a modernized cycle, with a different fuel, original design, and power scheme. This direction also includes the application of new high-performance elements in the engine: bearings, seals, coatings, etc. The second direction is related to the improvement of existing structures, increasing their efficiency by more detailed working conditions forecasting based on the use of modern computing software systems. This article presents a study of the potential mechanical face gas dynamic seal (FGDS) in the support in an aircraft engine compressor. Aircraft engines are characterized by multi-mode operation and high temperature levels in the internal cavities. For a FGDS operating with a working gap of several microns the exact determination of the deformation value is a very important result of the design process. This article considers the influence of the convective heat transfer coefficients distribution on the value of sealing rings thermal deformations. To achieve this goal, two compaction models were created: the gas-dynamic model for determining the convective heat transfer coefficients in the ANSYS CFX software program; and the structural model for calculating the resulting deformations. Interaction between the models was performed based on a specially created methodology. The obtained results can be used in the design of a FGDS for the supports in the compressors of aircraft engines and power plants.

Effect of part deformation on performance of a rotary compressor using propane under high temperature

Real Gas Effects on Charging and Discharging Processes of High Pressure Pneumatics

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation

Research on thermal deformation and clearances of oil-free twin screw compressor under cryogenic conditions

Mechanical property and sealing performance analysis of the diaphragm compressor cylinder head for the hydrogen refueling station under the mutation impact load

Optimization of Propane Compressor Capacity and Flow Rate in Refrigeration System

The effect of convection area on the deformation of dry gas seal operating with supercritical CO2

Parametric analysis on multi-stage high pressure reducing valve for hydrogen decompression

Performance improvements evaluation of an automobile air conditioning system using CO2-propane mixture as a refrigerant

The influence of nonuniform heat transfer coefficient distribution on the value of thermal deformations in mechanical gas dynamic seal rings

An 11-Stage Axial Compressor Performance Simulation Considering the Change of Tip Clearance in Different Operating Conditions

Performance of a linear refrigeration compressor with small clearance volume

Experimental Research on Vapor-Injected Rotary Compressor Through End-Plate Injection Structure with Check Valve

Simulation on two-phase refrigerant compression in the cylinder of rotary compressors using CFD method

Performance investigation and optimization analysis for vapor injection rotary compressor oriented to circular end-plate injection port without check valve

A Novel Vapor Injection Structure on the Blade of A Rotary Compressor

Performance analysis for a rotary compressor at high speed: experimental study and mathematical modeling

Experimental Investigation on the Steady-State Performance and Piston Stroke Length Control of A Variable Displacement Wobble Plate Compressor

Numerical analysis of vane–slot friction pair in a rolling piston compressor considering deformation and groove design

Effect of elastic deformation on the heat transfer characteristic of refrigerator gasket based on static analysis of structural assemblies

Optimization analysis of linear compressor using R290 for capacity-modulation performance improvement