Abstract:The wear of oil pump vanes easily leads to the noise and vibration, even results the decrease of volume efficiency and total efficiency. In order to reduce the friction and improve the lubrication between the vane and the pump inner wall, the micro-machining of micro-structure on the oil pump vanes is proposed. First, the micro-V-grooves with the depth ranging from 500 mu m to 50 mu m were micro-grinding on the top of the vanes by a diamond grinding wheel. Secondly, the experiments were conducted to test the actual flow rate, the output power and the overall efficiency of the oil pump with and without the micro-groove vanes. Then, the computational fluid dynamics (CFD) method was adopted to simulate the pump internal flow field. Finally, the micro-flow field between the internal wall of the oil pump and the top of micro-grooved vanes was analyzed. The results shows that the pump overall efficiency increased as the decrease of micro-groove depth from 500 mu m to 50 mu m and not be affected by the rotate speed and working frequency of the pump rotator. Especially the micro-groove with depth of 50 mu m, the actual flow rate, the output power and the overall efficiency reached to the maximum. From CFD simulation, the velocity of the micro-flow between the surfaces of the vane and inner wall was larger than the pump linear velocity when the microstructure depth is larger than 50 mu m, leading to an internal leakage. When the micro-groove depth is between 10-50 mu m, the velocity of the micro-flow was less than the pump linear velocity and no internal leakage was found, but the oil film thickness is too small to be beneficial to lubrication according to the fluid dynamic characteristics. Thus, for the oil pump equipping with micro-grooved vane with the depth of 50 mu m, the internal leakage not only is avoided but the lubrication efficiency is improved and the oil pump efficiency is also enhanced.

Numerical analysis of vane–slot friction pair in a rolling piston compressor considering deformation and groove design

Dynamic modeling and characteristics analysis of sliding vane in a high-speed rotary compressor considering groove distribution and multi-body coupling

Numerical Analysis of Lubrication Property for Port Plate Pair of Axial Piston Pump

Experimental Study of Frictional Torque Properties of Plane Port Pairs in Axial Piston Pump

Study on Friction Characteristics of Slipper Pair of Large Displacement High-Pressure Piston Pump

Analysis of Friction Characteristics of Pneumatic Cylinders Based on LuGre Model

FEM Based Simulation Study on Static and Dynamic Properties of Port Plate in Axial Piston Pump

Research on motion and friction of rolling piston in rotary compressor

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Numerical Analyses of Hydrodynamic Lubrication and Dynamics of the Rolling Piston and Crankshaft in a Rotary Compressor

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation

Theoretical Model Development and Mixed Lubrication Analyses of Rolling Piston Type Rotary Compressors: A Review

Numerical analyses of THD lubrication and dynamics of rolling piston and bearings in a rotary compressor

Investigation on Structural Optimization of Anti-Overturning Slipper of Axial Piston Pump

Lubrication and Fluid Film Study on the Vane Tip in a Vane Pump Hydraulic Transmission Considering a Fluid and Structure Interaction

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump

The Mechanism Performance of Improved Oil Pump with Micro-Structured Vanes

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Analysis and Optimization on U-shaped Damping Groove for Flow Ripple Reduction of Fixed Displacement Axial-Piston Pump

A Numerical Analysis for Piston Skirts in Mixed Lubrication: Part II—Deformation Considerations

Numerical and experimental study on flat roller/cam pair in a two-dimensional piston pump