Abstract:The dual-cylinder opposed linear compressor (DOLC) contains a couple of symmetrical gas loads on the two sides of the movement components. Because the gas loads are symmetrical, the balanced position of movement components will not be offset by gas force during the operating process, and piston displacement can be detected and controlled more easily. Based on the kinetics and thermodynamics theory, the non-linear gas load of the DOLC was linearized by the Fourier method. The relationship between the supply voltage and displacement is presented. Through air compression experiments, the operation features of the DOLC with different syntonic spring groups were analyzed. The performance of the DOLC was considerably affected by work conditions and the stiffness of syntonic spring groups; the closer the work condition was to the sympathetic vibration, the higher the observed efficiency of the DOLC. A jump, hysteresis, and an unstable phenomenon in the process of voltage regulation occurred around sympathetic vibration conditions. In the process of increasing voltage on a certain discharge pressure condition, the displacement jump phenomenon occurred when the intrinsic frequency approacheds power frequency, causing the discharge pressure to drop synchronously. In the process of decreasing voltage on the lower discharge pressure condition, the displacement shrink phenomenon occurred when the intrinsic frequency approached power frequency. Because sympathetic vibration conditions changed with discharge pressures, a hysteresis district existed between the displacement jump point and shrink point. The DOLC worked unstably on the hysteresis district because the discharge pressure fluctuated between the two values. To make the DOLC work stably on higher efficiency, the intrinsic frequency should be configured to a slightly larger value than the power frequency by setting the syntonic spring groups and the mass of movement components to the ratings on the work conditions. Controlling the power frequency after is needed to adhere to the intrinsic frequency of the variable work conditions.

Experimental Investigation on the Steady-State Performance and Piston Stroke Length Control of A Variable Displacement Wobble Plate Compressor

Experimental investigation on the characteristics of variable displacement swash plate compressor

Experimental investigation and numerical simulation on the hysteresis zone of a variable displacement wobble plate compressor

Piston Stroke Measurements in Variable Displacement Compressors

Dynamic Performance of Reciprocating Compressor with Capacity Regulation System

Study on Flow Field in Capacity Regulating Actuator for Reciprocating Compressor

A Mathematical Model of Variable Displacement Wobble Plate Compressor for Automotive Air Conditioning System

Theoretical Analysis and Realization of Stepless Capacity Regulation for Reciprocating Compressors

Self-Sencing Control Research on a Linear Compressor

Resistance Torque Based Variable Duty-Cycle Control Method for A Stage Ii Compressor

Performance testing with RC load approach in linear compressors

Performance Characteristics Around the TDC of Linear Compressor Based on Whole-Process Simulation

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Experimental Investigation on Off-Design Characteristics of R290 Rolling Piston Compressor

Transient Behavior Evaluation of an Automotive Air Conditioning System with a Variable Displacement Compressor

Simulation and Performance Analysis of Control Mechanism in Variable Displacement Swash Plate Compressor

Theoretical and Experimental Investigations on the Piston Offset Characteristics in a Four-Stage DC Linear Compressor Unit for a 1.8 K Hybrid Cryocooler

Stroke Estimation For Linear Compressor With Energy Method

Performance Testing of Linear Compressors with Rc Approach

Experimental Investigation and Performance Analysis of a Dual-Cylinder Opposed Linear Compressor

Experiments on Air Compression with an Isothermal Piston for Energy Storage