Abstract:Introduction: Increasingly aspherical optics are used in contact lens designs to produce a varifocal effect to correct presbyopia. Whilst no current ISO standard describes a method to verify these products, the vertex power needs to be verified by the manufacturer and optometrist. Visionix claim that the VC2001 instrument is able to resolve the vertex power of complex contact lenses and that it has been adopted by contact lens manufacturers as their "gold standard" method of measure. Practitioners rely on the focimeter for contact lens verification and accept that it has poorer resolution. This raises the question of whether practitioners can verify the vertex powers of varifocal contact lenses to a sufficient sensitivity. The purpose of this study is to determine whether a focimeter can differentiate between various vertex powers incorporating differing degrees of asphericity that are used in contact lens designs. Methods: A range of varifocal contact lenses were used with single vision contact lenses as controls. Three types of focimeters were used: a manual focimeter, a projector focimeter and a computerised focimeter (standard and contact lens modes). The VC2001 assessed the vertex powers over the optical zone and was used as a reference for the focimeters. The measures from the VC2001 and the focimeters were analysed by discrepancy analysis. Results: All discrepancy measures fell outside two standard deviations for either the varifocal contact lenses or the single vision contact lenses when the focimeters were compared to the VC2001. This raises the issue of whether the focimeters are measuring the same parameter as the VC2001. Only the analysis of the repeated measurements from the manual focimeter for single vision contact lenses demonstrated an acceptable measure of precision (+/-0.21, 2S.D.) with a very small degree of bias (mean difference -0.024, +/-0.02 [2S.E.]). Conclusion: These results suggest that the manual focimeter can measure the vertex powers for single vision contact lenses to an acceptable degree of precision. The vertex powers of varifocal lenses cannot be verified using standard practice equipment. The VC2001 has poor precision for power measurements and may not be measuring the same parameter as the focimeters and therefore questions the validity of the VC2001 as the "gold standard" for vertex power measurement.

Calibration Error on the Measurement of Back Vertex Power for Contact Lenses with Method Using Focimeter with Manual Focusing

Overcoming the error of power measurement caused by the curvature radius

Calibration for the Errors Resulted from Aberration in Long Focal Length Measurement

Overcoming the Error of Optical Power Measurement Caused by the Curvature Radius.

Calibration Method for High Accuracy Measurement of Long Focal Length with Talbot Interferometry: Reply

Calibration Method for High-Accuracy Measurement of Long Focal Length with Talbot Interferometry.

Verification of the vertex powers of varifocal rigid contact lenses

Assessment of the performance of automated focimeters in the measurement of single vision spectacle lenses

Focal Length Measurement Method for Lenses with Small Aperture and Long Focal Length

Aberration Calibration in High-Na Spherical Surfaces Measurement on Point Diffraction Interferometry

Spherical Aberration Compensation Method for Long Focal-Length Measurement Based on Talbot Interferometry

Analysis and correction of spherical aberrations in long focal length measurements

Practical and Accurate Method for Aspheric Misalignment Aberrations Calibration in Non-Null Interferometric Testing

Comparison of Refractive Error Measurements between KR-1W Wavefront Analyser and KR-8800 Automatic Refractometer in School children

Error Sources and Correction of Intraocular Lens Power Calculation after Corneal Refractive Surgery

Analysis and Calibration of Defocus Detection System Based on Astigmatism Method

Inter-laboratory reproducibility of power measurement of toric hydrogel lenses using the focimeter and the Moiré deflectometer

Calibration and Measurement Method Based on Optical Lenses for Large-Scale 3-D Precise Measurement

An Investigation on the Consistency Between Autorefraction and Subjective Refraction

Accuracy of WASCA aberrometer refraction compared to manifest refraction in Chinese adult myopes.

Investigation of the accuracy and quality in myopic college freshmen spectacles