Abstract:This study reports the investigation of the morphology of the surface damaged during the laser scribing of glass and the analysis of the corresponding interaction mechanism between the laser and glass. In this study, the soda lime glass of 1.1 mm thick is scribed by an ultraviolet (UV) picosecond laser (Nd:YVO4) by varying laser power, scan speed and number of scans. From the analysis of experimental results, it is found that the surface morphology can be classified as three groups such as swelled surface, wave pattern (either shallow or deep) and groove depending on the accumulated laser energy per unit beam spot. The accumulation of the large laser energy (12–30 × 10−4 J) into the material induces volume meting and local vaporization below the surface without material removal, which makes bubbles inside glass volume and swelled surface through volume expansion. With the decrease of the energy accumulation (4.2–9 × 10−4 J), the surface morphology is changed into shallow wave pattern by slight material removal. With further decrease of the laser energy accumulation (1.4–3 × 10−4 J), either deep wave or groove morphology is obtained due to the increase of the material removal. Under very low laser energy accumulation region (0.3–1.05 × 10−4 J), the groove shape is only formed. In particular, the groove morphology without cracking is successfully produced within the range of 0.3–0.5 × 10−4 J. The threshold laser energy accumulation for surface damage is found to be around 0.25–0.3 × 10−4 J. Below this energy accumulation, modification in the surface morphology doesn’t occur. It is also found that the groove morphology is hard to obtain by even multiple laser scans if it is not well formed by single laser scan. The cracks produced during the scribing process can be characterized with several propagation morphologies. At the region of the relatively low laser energy accumulation, cracks propagating across the scan direction are only generated. However, cracks propagating both across and along the scan direction are found with the increase of the laser energy accumulation. Huge cracks (arc or sinusoidal curve shape) of several millimeters in size are produced under the very large laser energy accumulation.

13.1: Effect of Scribing Wheel Dimensions on the Cutting of LCD Glass Substrate

Influence of glass substrate thickness in laser scribing of glass

A Machining Science Approach to Dental Cutting of Glass Ceramics Using an Electric Handpiece and Diamond Burs

Effect of bottom deformation on median crack repropagation after wheel scribing in glass

Development of a diamond scribing wheel with unequal-pitch micro-penetration teeth

Experimental investigations into the effect of process parameters on the machining quality for ITO conductive glass by using microgroove grinding

Influence of thermal expansion coefficient in laser scribing of glass

Thermal stress analysis on laser scribing of glass

Research of Cutting Process of TP Glass

Influence of diamond wire saw slicing parameters on (010) lattice plane beta-gallium oxide single crystal wafer

Three-dimensional thermal stress analysis on laser scribing of glass

Effect of Tool Rake Angle and Crystal Orientation on Ductile Mode Cutting of Hard/Brittle Materials

Impact of Drawing Machine Parameters on Force and Energy Consumption in Borosilicate Glass Tube Production

Mechanically inspired laser scribing of thin flexible glass

Fabrication of Vitrified Bond Diamond Grinding Wheel via LCD Photopolymerization

Investigation of the surface morphology in glass scribing with a UV picosecond laser

Single diamond scribing of SiCf/SiC composite: Force and material removal mechanism study

Investigation on the crack fracture mode and edge quality in laser dicing of glass-anisotropic silicon double-layer wafer

Effect of surface acid etching on the biaxial flexural strength of two hot-pressed glass ceramics

Orthogonal experimental study on the influence of machining parameters on flat lapping of sapphire substrate

Effects of raw material ratio and post-treatment on properties of soda lime glass-ceramics fabricated by selective laser sintering