Abstract:The SPH simulation model of optical quartz glass was established to study the ductile machining process with different tool rake angles. The material removal mode, stress distribution, cutting force, and subsurface damage during machining were analyzed. The critical cutting depths of brittle-ductile transition under different tool rake angles were obtained. The simulation results show that the tool negative rake angle is better than the positive rake angle in promoting the ductile machining of optical quartz glass. When the tool rake angle is negative, significant compressive stress which suppresses the crack generation by reducing the stress intensity factor KI is generated in the chip forming area, thus realizing the ductile machining of optical quartz glass. The greater the tool negative rake angle is, the more stable the cutting force and the greater the critical cutting depths of brittle-ductile transition are. When the tool negative rake angle is greater than − 35°, the subsurface damage of the optical quartz glass is aggravated, and the subsurface residual stress is complicated. When the tool negative rake angle ranges from − 15° to − 35°, the optical quartz glass is not only machined in a stable ductile region but also has less subsurface damage. Finally, nano-scratch experiments were carried out, and the critical depths of the brittle-ductile transition obtained by the experiments are basically consistent with the simulation results, which verify the correctness of the simulation results. The research results in this paper could provide a theoretical basis for the optimal selection of tool rake angle in the ductile machining of optical quartz glass.

Effect of Tool Rake Angle and Crystal Orientation on Ductile Mode Cutting of Hard/Brittle Materials

Study of the Influence of Tool Rake Angle in Ductile Machining of Optical Quartz Glass

A Machining Science Approach to Dental Cutting of Glass Ceramics Using an Electric Handpiece and Diamond Burs

0706 Uctile Cutting of a Microstructure Array on Silicon Surface by Using a Diamond Tool with a Negative Rake Angle

Effects of the Tool Angles on the Machined Surface Quality of KDP Crystal in Diamond Turning

Effect of cutting tool geometries on the ductile-brittle transition of monocrystalline sapphire

Effect of Crystallographic Orientation on Cutting Forces and Surface Finish in Ductile Cutting of Kdp Crystals

Investigation of Anisotropic Mechanisms in Ultra-Precision Diamond Machining of KDP Crystal

Finite element analysis of the effect of tool rake angle on brittle-to-ductile transition in diamond cutting of silicon

Effect of tool rake angle on the material removal mechanism transition of single-crystal silicon: a molecular dynamics study

Research on Influence of the Material Anisotropy to the Surface Quality During SPDT Machining of Crystal KDP

Ultraprecision Ductile-Regime Cutting of Brittle Materials

Influence of crystallographic effect on tool wear, cutting stress, cutting temperature, cutting force and subsurface damage in nano cutting of single crystal silicon carbide

Effects of vibration trajectory on ductile-to-brittle transition in vibration cutting of single crystal silicon using a non-resonant tool

Effect of Anisotropy on Cutting Force of Single Point Diamond Turning KDP Crystal

Effect of Rake Angle on Cutting Performance During Machining of Stone-Plastic Composite Material with Polycrystalline Diamond Cutters

Anisotropic cutting mechanisms on the surface quality in ultra-precision machining of R-plane sapphire

Rake Angle Effect on a Machined Surface in Orthogonal Cutting of Graphite/Polymer Composites

Effects of Diamond Cutting Tool'S Rake Angle and Edge Radius on the Diamond Turned Surface Quality

Experimental and Theoretical Investigation on the Ductile Removal Mechanism in In-Situ Laser Assisted Diamond Cutting of Fused Silica

Research on Nano-Cutting Processes Based on Parallel Molecular Dynamics