Abstract:There are many applications from computer hardware and sensors to thin films and coatings in which parts are fabricated in small sizes and low thicknesses. Most of these applications could undergo cyclic loading and unloading conditions during their operation. Therefore, cyclic and fatigue evaluations of these components are an essential topic and should be fully understood. In these cases, due to the dimensional limitations, conventional methods of the fatigue experiments encounter challenges and mostly are not accurate or applicable. Nano- and micro-indentation fatigue tests are considered non- or semi-destructive experiments that have opened a new approach to study the cyclic response of these small-sized specimens and thin films. The objective of the present review paper is to evaluate a convenient, reliable, and non-destructive testing approach in the assessment of fatigue (cyclic) response of materials on a small scale. Along with conventional bulk scale fatigue testing methods (i.e. reverse bending, pull-push, multi-axial bending), the depth-sensing indentation testing technique can be employed to study the cyclic behavior of metallic and non-metallic materials especially when a limited volume of the material is available. In this paper, we tried to cover most of the previous studies performed on indentation fatigue of composites, thin films, coatings, and ceramics along with associated discussions and main findings. We covered the physics behind the indentation and the difference between the indentation and conventional fatigue analyses. Followed by that, microstructural evaluations of some of the studies are provided to give readers more insights into this approach. In most applications, the indentation fatigue technique could be a reliable solution due to its accuracy, simplicity, and nondestructive approach in finding out the fatigue and cyclic behavior of materials having a small size or volume. It is worth noting that the loading mode in the indentation fatigue is completely different than the traditional (bulk-scale) fatigue as the tensile segment of the load cycle is not produced in the indentation fatigue (it is a compression-compression loading cycle). Therefore, the controlling mechanisms of failure between small-scale fatigue and bulk-scale fatigue may not be the same.

Small specimen techniques for estimation of tensile, fatigue, fracture and crack propagation material model parameters

Influence of specimen dimensions and strain measurement methods on tensile stress–strain curves

Study of Ligament Length Effect on Mode Mix of a Modified In-Plane Shear Test Specimen

Non-conventional Small-Scale Mechanical Testing of Materials

A review of selected small specimen test techniques for identifying deformation and failure properties of metallic materials

Analysis of Large Deformation and Fracture of Axisymmetric Tensile Specimens

A Miniaturized Device Coupled with Digital Image Correlation for Mechanical Testing

Semi-automatic miniature specimen testing method to characterize the plasticity and fracture properties of metals

Numerical Investigation of Frictional Effect on Measuring Accuracy of Different Small Specimen Creep Tests

Finite Element Stress and Strain Analysis of a Double Shear Creep Specimen

The development of small specimen mechanical test techniques

Optimizing Parallel Section Length For Small Tensile Specimen With Fabrication Non-Uniformity In Thickness

Estimation of Fracture Toughness with Small Specimens Based on TSM Model

Microstructurally small fatigue crack growth rates in aluminium alloys for developing improved predictive models

Investigative Method for Fatigue Crack Propagation Based on a Small Time Scale.

On the use of representative specimens for the structural integrity assessment of safety-relevant rotating components

Effect of Stress Regime‐dependent Creep Behaviour on Measurement of Creep Strain Rate Based on Small Specimen Techniques

An overview of microscale indentation fatigue: Composites, thin films, coatings, and ceramics

Modelling of crack propagation in miniaturized and normal SENB specimens based on local failure criterion

A comprehensive solution to miniaturized tensile testing: Specimen geometry optimization and extraction of constitutive behaviors using inverse FEM procedure

In-Situ Fatigue Crack Growth Testing of Al7075-T651 under Scanning Electron Microscopy