Abstract:Phenolic resins occupy an important position in industrial applications, but phenol, one of the raw materials for synthesis, is a non-renewable resource. Lignin, as a natural polymer containing phenolic hydroxyl groups, alcohol hydroxyl groups and other reactive groups, can replace some of the phenol in the synthesis of phenolic resins, which can reduce the amount of phenol, thus reducing the cost of phenolic resins, while effectively promoting the high value-added use of renewable biomass resources. Due to its low reactivity, alkaline lignin is usually discharged as production waste, unaware that lignin macromolecules can be modified. In this paper, the phenolic monomers were obtained by acid-catalyzed depolymerization of DES (choline chloride/p-toluenesulfonic acid or choline chloride/lactic acid) from waste alkaline lignin, and the recovery rate of the DES solution during the catalytic treatment was more than 85 %, in which the main monomer was 2-methoxy-4-(1-propyl) phenol. The degradation of alkaline lignin is still favorable after five times of DES solvent recovery. The depolymerized lignin monomer replaced phenol by 50 wt% and then ternary co-polymerized with phenol and formaldehyde to form a biomass phenol-based phenolic resin, providing a green route for phenolic resin production. The cost of resin preparation was economically calculated, and it was found that the cost of resin after accumulating 4 cycles of DES treatment was only 51.1 % of that of pure phenolic resin. The density functional theory (DFT) was used to simulate the possible radical reactions in the intermediate process of phenolic resin reaction, to explore the microscopic mechanism and competition, to provide theoretical reference for further experimental realization of resin structure control and optimization, and to improve the theoretical system of resin synthesis.

Pretreatment of kraft lignin by deep eutectic solvent and its utilization in preparation of lignin-based phenolic formaldehyde adhesive

Improving the Reactivity of Sugarcane Bagasse Kraft Lignin by a Combination of Fractionation and Phenolation for Phenol-Formaldehyde Adhesive Applications

Effect of Lignin Structure Characteristics on the Performance of Lignin Based Phenol Formaldehyde Adhesives.

Preparation, optimisation and characterisation of lignin phenol formaldehyde resin as wood adhesive

Phenolation to Improve Hardwood Kraft Lignin for Wood Adhesive Application

Preparation and evaluation of lignin-phenol-formaldehyde resin as wood adhesive using unmodified lignin

Preparation And Performance Of Lignin-Phenol-Formaldehyde Adhesives

Kraft lignin in phenol formaldehyde resin. Part 1. Partial replacement of phenol by kraft lignin in phenol formaldehyde adhesives for plywood

Investigating the Depolymerization Behavior of Structurally Modified Kraft Lignin in Deep Eutectic Solvents

Synthesis of phenolic resins by substituting phenol with modified spruce kraft lignin

Preparation of highly water-resistant wood adhesives using ECH as a crosslinking agent

Preparation and Characterization of Phenol-Formaldehyde Adhesives Modified with Enzymatic Hydrolysis Lignin

A Comparison among Lignin Modification Methods on the Properties of Lignin–Phenol–Formaldehyde Resin as Wood Adhesive

Phenolation Modification of Wheat Straw Soda Lignin and Its Utilization in Preparation of Lignin-Based Phenolic Formaldehyde Resins Adhesive

Study on Enzymatic Hydrolysis Lignin Modified Phenol Formaldehyde Resin

Glucose-lignin-based phenolic resin: an environmentally friendly low-formaldehyde wood adhesive

Demethylation of lignin with mild conditions and preparation of green adhesives to reduce formaldehyde emissions and health risks

Characterization and properties of phenolic resin doped modified lignin

Activation of Cellulosic Ethanol Lignin by Laccase and Its Application As Plywood Adhesive

Demethylation and other modifications of industrial softwood kraft lignin by laccase-mediators

High-performance adhesives modified by demethylated lignin for extreme environment