Abstract:The effects of nanosized reinforcement particles on precipitation reactions in age-hardenable Al alloy matrix composites have been largely unknown. In this work, an Al-Zn-Mg-Cu matrix composite reinforced with uniformly distributed TiB2 nanoparticles was successfully produced. The solid-soluted, peak-aged and overaged materials were then characterized, at the atomic scale using (high-resolution) scanning transmission electron microscopy, to provide a fundamental insight into the interface precipitation. Our results demonstrated that the facetted TiB2 nanoparticles have a significant impact on the precipitation in matrix areas adjacent to the TiB2/Al interfaces. The interfaces after solid-solution treatment are tightly-bonded and oxide-free, and display two orientation relationships (ORs): the well-reported [21¯1¯0]TiB2//[101]Al, (0001)TiB2//(1¯11)Al (OR1) and the new [21¯1¯0]TiB2//[101]Al, (011¯0)TiB2//(111¯)Al (OR2). The interface precipitates (i.e. interphase) having the size of several tens of nanometers were formed after ageing and were determined to be (Zn1.5Cu0.5)Mg phase. Their formations were only related to the initial OR1 and OR2 where the mutual ORs between the TiB2, interphase and Al matrix were further developed. Periodically spaced misfit dislocations were revealed at the semi-coherent TiB2/Al interfaces, which are generally considered beneficial to the heterogeneous precipitation. They not only reduced nucleation energy barrier, but also acted as short-circuit diffusion paths for transporting solute atoms and vacancies, accelerating growth rate. However, the growth of interphase at the interface parallel to close-packed {111} Al planes was suppressed by the ultra-low accommodation factor. In addition, such an interface precipitation reduced the mismatch of the TiB2/Al interface, increasing the overall coherency and being potential for effective interface strengthening.

Composite precipitates in a commercial Al–Li–Cu–Mg–Zr alloy

Evolution of Precipitate and Precipitate/matrix Interface in Al-Zn-Mg-Cu(-Ag)alloys

High-Resolution Electron Microscope Observation of Interface Microstructure of A Cast Al-Mg-Si-Bi-Pb(6262)/Al2o3p Composite

Interfacial structure evolution of the growing composite precipitates in Al-Cu-Li alloys

Interfacial Segregation and Precipitates Behavior in the Ultrafine Grained Al-based Metal Matrix Composites

Uncovering the influence of Cu on the thickening and strength of the δ′/θ′/δ′ nano-composite precipitate in Al–Cu–Li alloys

First-principle investigation on the interfacial structure evolution of the δ'/θ'/δ' composite precipitates in Al-Cu-Li alloys

Microstructure and chemistry of the composite precipitate structure in Al-Li-Cu alloy

Atomic-scale investigation of the interface precipitation in a TiB2 nanoparticles reinforced Al–Zn–Mg–Cu matrix composite

The influence of Cu/Li ratio on precipitation in Al–Cu–Li–x alloys

Study of the precipitate evolution mechanism in an Al-Mg-Si-Cu alloy with Si-rich and low Cu composition

Characterization of precipitation in Al-Li alloy AA2195 by means of atom probe tomography and transmission electron microscopy

Microstructure evolution and shearing behaviour of δꞌ/θꞌ/δꞌ precipitates in an aged Al-Cu-Li-Mg aluminium alloy

Insights into precipitation characteristics and strengthening mechanisms in a low Cu/Mg ratio Al-Cu-Mg-Ag alloy

The effect of major constituents on microstructure and mechanical properties of cast Al-Li-Cu-Zr alloy

Heterogeneous nucleation of T1 precipitates in solid solution of Al-Cu-Li alloys from Ag-rich structures: An ab initio study

Precipitation behavior in the early stage of aging in an Al–Li°Cu–Mg–Zr–Ag (Weldalite 049) alloy

Nucleation and evolution mechanism of precipitates during the initial aging stage in Al-Zn-Mg-Cu alloy

Precipitate microstructures, mechanical properties and corrosion resistance of Al-1.0 wt%Cu-2.5 wt%Li alloys with different micro-alloyed elements addition

Investigation on formation mechanism of T1 precipitate in an Al-Cu-Li alloy