Abstract:To optimize the configuration of spatial-temporal resources at intersections with mixed traffic flow of passenger cars and heavy vehicles, this paper proposes a set of mixed integer linear programming（MILP） model with aim to maximize the intersection capacity. In the model, different impacts of the locations of permitted lanes on flows of different modes and vehicle turning maneuvers are considered to increase the model applicability. The constrains on the relative setting position of permitted lanes for left-turn, through and right-turn are released. That’s to say, the permitted left-turn lanes don’t have to be on the left of the permitted through lanes, and the permitted through lanes don’t have to be on the left of the right-turn permitted lanes. This may induce some new flow conflicts（potential conflicts） and whether these conflicts exist is affected by the lane channelization scheme. Thus, some constraints are added in the model, among which one is to identify which potential conflicts are arisen with specific lane scheme, the other is to determine these conflicts’ impact on the configuration of temporal resources at intersections. The results from numerical tests show that this impact will change the configuration of spatial-temporal resources at intersections.Compared with the conventional lane-based model, the modified model can significantly improve the intersection maximum capacity while ensure safe flow propagation. The improvement on the intersection maximum capacity increases with the heavy vehicle proportions and the impact of lane location on travel efficiency. But with the increase of the difference of travel efficiencies between heavy vehicles and passenger cars, the improvement first increases and then decreases.

Flow feasibility condition analysis and design optimization of contraflow left-turn lanes at signalized intersections based on kinematic wave theory

Analysis om waiting area for left-turn vehicles at signalized intersections

Optimization of Signal Timing for the Contraflow Left-Turn Lane at Signalized Intersections Based on Delay Analysis

Traffic Signal Control Optimization Strategy Based on Simulation

Signal Timing Optimisation with the Contraflow Left-Turn Lane Design Using the Cell Transmission Model

Method of computing left-turn vehicle traffic capacity at two-phase intersection

Analysis of a Signalized Intersection with Dynamic Use of the Left-Turn Lane for Opposite through Traffic

Critical Condition for Setting Left-turn Waiting Area

Delay Estimation and Application Conditions of Two-Legged Continuous Flow Intersection

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Planning methods and effect analysis of advance right-turn

Modeling Capacity of Shared Right-Turn Lanes at Signalized Intersections Considering the Lag Green Time of Right-Turns

Optimization of Stretching-Segment Design and Signal Timing in Traffic Control

Conflict delay models at two-phase intersection

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Configuration of Spatial-temporal Resources at Intersections Considering Travel Efficiencies of Mixed Flows

A Cooperative Optimization Model for Variable Approach Lanes at Signaled Intersections Based on Real-Time Flow

Signal Timing Method of Right——turn Vehicles Based on Mixed Traffic

Simulation of Departure Flow Profile at Stop Lines for Signal Approach Spillover

Increasing the Capacity of Signalized Intersections by Allocating Exit Lanes to Turning Movements

Calculation method of travel time of right-turn vehicle at motor-and nonmotor-vehicle mixed traffic intersection