Abstract:Purpose This paper is aimed at clarifying the behaviour of concrete-filled stainless steel tube (CFSST) slender columns. Based on the review of previous works, it can be found that the pieces of research on the behaviour of CFSST slender columns are very rare and the existing studies, to the author’s knowledge, have not covered this topic in greater depth. The purpose of this paper is to investigate the structural response and strength capacity of eccentric loaded long CFSST columns. Design/methodology/approach In this paper, a new finite element (FE) model is presented for predicting the nonlinear behaviour of CFSST slender columns under eccentric load. The FE model developed accounts for confinement influences of the concrete in-filled material. In addition, the initial local and overall geometric imperfections were introduced in the numerical model in addition to the inelastic response of stainless steel. The interaction between the stainless section and concrete in-filled was modelled using contact pair algorithm. The FE model was then verified against an experimental work presented in the literature. The ultimate strengths, axial load–lateral displacement and failure mode of CFSST slender columns predicted by the FE model were validated against corresponding experimental results. Findings The simulation results show that the improvement in the column strengths (compared to hollow section) is less significant when the composite columns have small width-to-thickness ratio. Finally, comparisons were made between the results obtained from FE simulation and those computed from the Eurocode 4 (EC4). It has been found that the EC4 predictions in most analysed cases are conservative for composite columns analysed under a combination of axial load and uniaxial or biaxial bending. However, the conservatism of the code is reduced with a higher slenderness ratio of the composite columns. Practical implications The simulation results throughout this research were compared with the corresponding Eurocode predictions. Originality/value This paper provides new findings about the structural behaviour of CFSST columns.

Investigating local buckling in highly slender elliptical hollow sections through analysis of 3D-printed analogues

Local buckling and ultimate strength of slender elliptical hollow sections in compression

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Experimental Analysis and Design of 3D-Printed Polymer Elliptical Tubes in Compression

Mechanical Modelling of the Strength and Stiffness of Circular Hollow Section Tube under Localised Transverse Compression and Tension

Behavior and Design of Slender Concrete-Filled Wide Rectangular Steel Tubular Columns under Axial Compression

Numerical Analysis on Global Stability Performance of Fold-Fastened Multi-Cellular Steel Walls

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Experimental Study and Finite Element Analysis on the Local Buckling Behavior of Aluminium Alloy Beams under Concentrated Loads

Numerical investigation and design for the local buckling behaviour of high strength steel hexagonal hollow section stub columns under axial compression

EXPERIMENTAL INVESTIGATION AND FINITE ELEMENT ANALYSIS OF LOCAL-OVERALL BUCKLING BEHAVIOR OF ALUMINIUM ALLOY BEAMS

Local buckling behaviour of welded I-section steel stub columns with longitudinally profiled steel plates under axial compression: Testing, modelling and design

Global buckling behaviour and design of square cold-formed concrete-filled dual steel stiffened slender columns

Local and post-local buckling of fabricated high-strength steel and composite columns

Numerical modelling of concrete-filled stainless steel slender columns loaded eccentrically

The 3D finite element analysis of nonlinear buckling bearing capacities of CFT with high slenderness ratio under eccentric load

Local Buckling Analysis of Aluminum I Section Beams

Study of Bearing Capacity of Aluminum Alloy Thin-Walled Circular Tube Filled with Lightweight Filler

Compressive testing and modelling of additively manufactured stainless steel equal angle sections with stiffening wave patterns

Numerical analysis of rectangular double-skin concrete-filled steel tubular slender columns incorporating interaction buckling