Abstract:The nucleation and growth of pure titanium nanoparticles in a low-pressure sputter plasma has been believed to be essentially impossible. The addition of impurities, such as oxygen or water, facilitates this and allows the growth of nanoparticles. However, it seems that this route requires so high oxygen densities that metallic nanoparticles in the hexagonal aTi-phase cannot be synthesized. Here we present a model which explains results for the nucleation and growth of titanium nanoparticles in the absent of reactive impurities. In these experiments, a high partial pressure of helium gas was added which increased the cooling rate of the process gas in the region where nucleation occurred. This is important for two reasons. First, a reduced gas temperature enhances Ti2 dimer formation mainly because a lower gas temperature gives a higher gas density, which reduces the dilution of the Ti vapor through diffusion. The same effect can be achieved by increasing the gas pressure. Second, a reduced gas temperature has a "more than exponential" effect in lowering the rate of atom evaporation from the nanoparticles during their growth from a dimer to size where they are thermodynamically stable, r*. We show that this early stage evaporation is not possible to model as a thermodynamical equilibrium. Instead, the single-event nature of the evaporation process has to be considered. This leads, counter intuitively, to an evaporation probability from nanoparticles that is exactly zero below a critical nanoparticle temperature that is size-dependent. Together, the mechanisms described above explain two experimentally found limits for nucleation in an oxygen-free environment. First, there is a lower limit to the pressure for dimer formation. Second, there is an upper limit to the gas temperature above which evaporation makes the further growth to stable nuclei impossible.

Titanium monoxide and titanium dioxide thin film formation by magnetron sputtering and its thermodynamic model

Crystallization Behaviors of TiO2 Films Derived from Thermal Oxidation of Evaporated and Sputtered Titanium Films

Preparation and Properties of Titanium Oxide Thin Film by Midfrequency Alternative Reactive Magnetron Sputtering Technique

Effect of the Substrate Temperature on the Crystallization of TiO2 Films Prepared by DC Reactive Magnetron Sputtering

Investigation of microstructure evolution in Pt-doped TiO2 thin films deposited by rf magnetron sputtering

Compositional and Structural Evolution of the Titanium Dioxide Formation by Thermal Oxidation

The mathematical fractional modeling of TiO_2 nanopowder synthesis by sol–gel method at low temperature

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

Model of Reactive Magnetron Sputtering of a Two-Component Composite Target

Investigations of Tio2 Films Prepared by Reactive Magnetron Sputtering

Nucleation of titanium nanoparticles in an oxygen-starved environment, II: Theory

Reactive pulsed direct current magnetron sputtering deposition of semiconducting yttrium oxide thin film in ultralow oxygen atmosphere: A spectroscopic and structural investigation of growth dynamics

Iterative composition optimization in –based thin-film thermoelectrics using single-target sputtering

Atomic-Scale Modeling of the Dynamics of Titanium Oxidation

Influence of the method of gas supply to the chamber on the processes of reactive magnetron sputtering of Ti-Al composite target

Improvement of titanium film uniformity by magnetron sputtering with electromagnetic coil design

Relationship Between Growth Surface Temperature and Crystal Structure of TiO2 Coatings Prepared Using Direct Current Pulsed Magnetron Sputtering Technology

Synthesis of Titanium-Based Powders from Titanium Oxy-Sulfate Using Ultrasonic Spray Pyrolysis Method

Deposition of the stoichiometric coatings by reactive magnetron sputtering

Surface temperature analysis of a hot titanium target in argon magnetron sputtering system

Formation and dissolution of porous magnetite layer in contact with lead-bismuth eutectic: Locally equilibrium thermodynamic model