Abstract:With increasing the possibilities of tribological applications for Al2O3 ceramic, much more attentions have been paid to researches on the tribological characteristics of Al2O3, such as compositions, microstructures, environments and other tribo-parameters. The effect of surface roughness of self-mated Al2O3 on friction and wear has been investigated at the present paper by varying the roughness parameters of samples under the conditions of reciprocating contact of cylinder-on-plate geometry lubricated by isooctane. In the tribotests, the roughness of plate samples were varied and they were ground by diamond grinding wheels. The surface of cylinders was, however, kept as delivered conditions. A dry air tribotest was also carried out to be as a reference test compared to lubricated tests. It has been found in this investigation that the increase of surface roughness results in high linear wear and friction coefficient of cylinder-plate tribopairs. It was observed that there exists a critical roughness about R-vk 1.89. High friction coefficient and linear wear will be got above this critical roughness. If the roughness of plate is below this critical value, friction coefficient and linear wear will be quite small after the test. It is also found by the SEM examinations of worn Surfaces that a thick third body layer is formed during the test with higher surface roughness of plates. The thin and compacted third body layer is formed with lower roughness of plates. Therefore, a carefully finished ceramic surface is extremely important to improve the tribological behaviours for engineering applications. It is interesting that the linear wear of as delivered cylinder-plate sample pairs is quickly levelled off in the dry air conditions even though their friction coefficient still keeps around 0.7. It can be concluded from this test that lubricant may have a negative effect on tribological behaviors.

Investigation of Factors Affecting Wear Characteristics in Rubber–Metal Sliding Contact

Rubber wear: experiment and theory

An investigation of the wear of polymeric materials

Experimental Study of Abrasive, Mechanical and Corrosion Effects in Ring-on-Ring Sliding Contact

Surface Roughness Effect on the Friction and Wear Behaviour of Acrylonitrile–Butadiene Rubber (NBR) Under Oil Lubrication

Tribological behavior of carbon steel 45 and brass H90 in dry sliding on bearing steel GCr15 in the sand-dust environment

Effect of load on the stick-slip phenomenon and wear behavior of EPDM

Study on Tribological Behavior of Grooved-Texture Surfaces under Sand–oil Boundary Lubrication Conditions

Influence of Counter Surface Roughness and Lay on the Tribological Behaviour of Self-Lubricating Bearing Materials in Dry Sliding Conditions at High Contact Pressures

Evaluation of polymer composites for sliding and abrasive wear applications

Effect Of Surface Roughness And Wear In Lubricated Of Self-Mated Alumina On Friction Reciprocating Sliding Contact

Simulation of Sliding Wear in Mixed Lubrication

Ball-on-flat linear reciprocating tests: Critical assessment of wear volume determination methods and suggested improvements for ASTM D7755 standard

Efficiency of surface texturing in the reducing of wear for tests starting with initial point contact

Experimental Investigate of the Wear and Friction Performance Considering Effects of Surface Topography and Lubricant

Effect of Molecular Structure on the Dry and Wet Abrasion Behavior of NR

Experiment and Simulation Research on the Fatigue Wear of Aircraft Tire Tread Rubber

The Effect of Wear on the Performance of a Rotary Lip Seal

Wear Characterization under Sliding–rolling Contact Using Friction-Induced Vibration Features

Abrasive and adhesive wear behaviour of metallic bonds in a synthetic slurry test for wear prediction in reinforced concrete

Acoustic Emission and Its Relationship with Friction and Wear for Sliding Contact