Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Simulation of sliver blending and evaluation of blending irregularity

Multi-Scale Computer Simulations of Polymer Blends

Simulation of Realistic Fabric Surfaces with BRDF Algorithm

Chaotic Mixing and Its Application in Polymer Blending

Study on the relationship between blending uniformity and yarn performance of blended yarn

Computer Simulation of Fancy Yarns Based on Structural Model of Appearance

Simulation on fiber random arrangement in the yarn part II: joint effect of fiber length and fineness distribution

Investigation into the effect of the blend ratio on the structure and properties of dual-feed-opening rotor-spun yarn

A Study on Grinding Surface Waviness of Woven Ceramic Matrix Composites

Blending effects and performance of ring-, rotor-, and air-jet-spun color-blended viscose yarns

Computer Simulation of Brocade Based on Modeling Structures

A New Algorithm for Yarn Simulation

A prediction method and its application for twist of slub yarn based on micro-element yarn

Investigation of the interactions between two contact fibers in the fiber suspensions

The model of ring-spun slub yarn based on random fiber arrangement and its application: Part 2 Prediction of morphology parameters for slub yarn and simulation of slub fabric

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Computational Simulation of Complex Structure Fancy Yarns

Practice of Spinning Richcel Blending Using the Cot WRC-963

Numerical Simulation of Particle Mixing Behavior in High Speed Shear Mixer and Cylinder Mixer

Enhancing the Spun Yarn Properties by Controlling Fiber Stress Distribution in the Spinning Triangle with Rotary Heterogeneous Contact Surfaces

A Spectro Photometric Color Matching Algorithm For Precolored Fiber Blends