Abstract:For the construction of long and continuous railway lines as well as the replacement of defected rails, rails are joined using flash-butt welding. Under various localized temperatures and thermo-mechanical stresses, a residual stress can develop in the flash-butt welded joint. The residual stress can affect the performance and reliability of the welded rail, particularly in terms of progressive structural damage caused by repeated wheel load. In the present work, the mechanisms of residual stress formation in a flash-butt welded rail and the influence of upsetting force (including its temperature range and magnitude) were investigated using the thermal elastic–plastic finite element analysis. The formation mechanisms of residual stress involved the changes in thermal expansion coefficient, strain, and elastic modulus of the welded joint with respect to temperature. The calculated cooling temperatures and residual stresses in the flash-butt welded joint were in good agreement with the measured results. Compressive residual stresses were observed around the rail head and the rail foot (i.e., approximately −648 MPa at the rail head and −495 MPa at the rail foot), while tensile residual stresses were observed at the rail web (i.e., approximately 165 MPa). It was observed that the investigated compressive upsetting force predominantly induced plastic deformation within the welded joint, resulting in minimal alteration of stress. Consequently, the investigated ranges of upsetting temperature and upsetting forces had an insignificant impact on the formation of residual stress.

Weldability of austempered rail steel using the flash-butt process

Influence of welding on microstructure and strength of rail steel

Flash butt welding of bainite steel crossing with U71Mn steel rail

The influence of technological parameters on the thermal cycle at butt flash welding of rails

Decomposition mechanisms of continuously cooled bainitic rail in the critical heat-affected zone of a flash-butt welded joints

Influence of Rail Metallurgy and Welding Parameterization on the Quality of Flash Butt Welds Done with Mobile Equipment

Mechanical and Tribological Behaviors of U75VG Rail Flash−Butt Welded Joint

Study of Melting Methods by Electric Resistance Welding of Rails

Study on microstructure and mechanical properties of continuous drive friction-welded joints of bainitic rail steel

Reduced spheroidization in rail flash-butt welding by selective alloying

Flash Butt Rail Weld Vertical Fractures

Flash Butt Welding of High Manganese Steel Crossing and Carbon Steel Rail

Numerical Investigation of Residual Stress Formation Mechanisms in Flash-Butt Welded Rail

Consequences of thermite welding on the microstructure of the heat affected zone of a carbide-free bainitic steel rail

Microstructural Evolution and Micro-Corrosion Behaviour of Flash-Welded U71Mn Joints as a Function of Post-Weld Heat Treatment

Effect of Alloying Composition on Microstructure and Mechanical Properties of Ultranarrow Gap Welded Joints of U71Mn Rail Steel

WELDING OF HIGH-MANGANESE STEEL CROSSING AND HIGH-CARBON STEEL RAIL

Influence of CDFW Process Parameters on Microstructure and Mechanical Properties of U75V Rail Steel Welded Joint

PROCESSES OF WELDED JOINT STRUCTURE FORMATION DURING ELECTRIC RESISTANCE WELDING OF RAILWAY RAILS

Development of the combined flashing method in welding of rails

The sensitivity analysis of microstructure and mechanical properties to welding parameters for linear friction welded rail steel joints