Abstract:Rail welded joint is one of weak links in high-speed railway, and its dynamic performance has important effects on the safety, stability, and comfort of the high-speed train. In this work, the dynamic mechanical responses at different regions of U75VG rail flash-butt welded joint were investigated. The results show that the base metal (BM), welding zone (WZ), and heat-affected zone (HAZ) of U75VG rail flash-butt welded joint has an obvious strain rate effect, i.e., the material strength increases with increasing the loading strain rate. The strength of WZ is similar to that of BM, but its toughness is much lower than that of BM. The toughness of HAZ is the same as that of WZ, but its strength is much lower than that of BM and WZ. Based on the experimental results, an improved dynamic constitutive model was established to reasonably simulate the stress–strain curves of different regions from quasi-static loading to dynamic loading. Finite element (FE) analysis of transient rolling contact between rail welded joint and wheel under different conditions was performed. Compared with the results from quasi-static wheel-rail contact simulation, the equivalent plastic strain at each region of rail welded joint increases significantly and presents non-uniform distribution after considering the dynamic effect. When the wheel contacts the junction between different regions, the impact will cause a significant stress concentration at the rail welded joints. The maximum wheel-rail load by the implicit dynamic analysis is about 4 ∼ 12 times that obtained by the quasi-static analysis. Moreover, the maximum contact pressure, equivalent stress and equivalent plastic strain of each area of rail welded joints gradually increase with the increase in axle load and driving speed.

Flash Butt Rail Weld Vertical Fractures

Mechanical and Tribological Behaviors of U75VG Rail Flash−Butt Welded Joint

Numerical Investigation of Residual Stress Formation Mechanisms in Flash-Butt Welded Rail

Influence of welding on microstructure and strength of rail steel

Rolling Contact Fatigue Damage in Welded Rail Steel Joints

Decomposition mechanisms of continuously cooled bainitic rail in the critical heat-affected zone of a flash-butt welded joints

Influence of Rail Metallurgy and Welding Parameterization on the Quality of Flash Butt Welds Done with Mobile Equipment

Weldability of austempered rail steel using the flash-butt process

Impact Wear of Flash- and Aluminothermic-Welded Hypereutectoid Steel Rail Joints

Flash butt welding of bainite steel crossing with U71Mn steel rail

Investigation of Welding Residual Stress in Flash-Butt Joint of U71mn Rail Steel by Numerical Simulation and Experiment

Experimental Study on Tensile Fracture Mechanism of Butt Joints in Multi-Celled CFST Walls

Combining welding-induced residual stress with thermal and mechanical stress in continuous welded rail

Influence of CDFW Process Parameters on Microstructure and Mechanical Properties of U75V Rail Steel Welded Joint

The sensitivity analysis of microstructure and mechanical properties to welding parameters for linear friction welded rail steel joints

Dynamic constitutive model of U75VG rail flash-butt welded joint and its application in wheel-rail transient rolling contact simulation

PROCESSES OF WELDED JOINT STRUCTURE FORMATION DURING ELECTRIC RESISTANCE WELDING OF RAILWAY RAILS

Study of Melting Methods by Electric Resistance Welding of Rails

Effect of laser shock peening on fatigue properties of U75VG rail flash-butt welding joints

The influence of technological parameters on the thermal cycle at butt flash welding of rails

Quasi-equal Strength and Toughness Matching Rail Steel Joint Obtained Via Friction Welding below Ac1 Temperature