Abstract:Currently, liquid-to-gas heat exchangers in buildings, domestic appliances and the automotive industry are mainly made of copper and aluminum. Using plastic instead of metal can be very beneficial from an economic and environmental point of view. However, it is required that a successful plastic design meets all the requirements of metal heat exchangers. The polymeric hollow fiber heat exchanger studied in this work is completive to common metal finned heat exchangers. Due to its unique design (the use of thousands of thin-walled microtubes connected in parallel), it achieves a high level of compactness and thermal performance, low pressure drops and high operation pressure. This paper focuses on an important aspect of heat exchanger operation—its fouling in conditions relevant to building and domestic application. In heating, ventilation and air conditioning (HVAC) and automotive and domestic appliances, outdoor and domestic dust are the main source of fouling. In this study, a heat exchanger made of polymeric hollow fibers was tested in conditions typical for indoor HVAC equipment, namely with the 20 °C room air flowing through the hot water coil (water inlet 50 °C) with air velocity of 1.5 m/s. ASHRAE test dust was used as a foulant to model domestic dust. A polymeric heat exchanger with fibers with an outer diameter of 0.6 mm (1960 fibers arranged into 14 layers in total) and a heat transfer area of 0.89 m2 was tested. It was proven that the smooth polypropylene surface of hollow fibers has a favorable antifouling characteristic. Fouling evolution on the metallic heat transfer surfaces of a similar surface density was about twice as quick as on the plastic one. The experimental results on the plastic heat exchanger showed a 38% decrease in the heat transfer rate and a 91% increase in pressure drops after eighteen days of the experiment when a total of 4000 g/m2 of the test dust had been injected into the air duct. The decrease in the heat transfer rate of the heat exchanger was influenced mainly by clogging in the frontal area because the first layers were fouled significantly more than the deeper layers.

Investigation of Crystallization Fouling on Novel Polymer Composite Heat Exchanger Tubes

Experimental research on flow resistance and heat transfer characteristics of polymer helical coils heat exchanger

Impact of Tube Surface Properties on Crystallization Fouling in Falling Film Evaporators for Seawater Desalination

Thermally conductive polypropylene composites as corrosion‐resistant materials for plate heat exchangers

Fouling of Polymeric Hollow Fiber Heat Exchangers by Air Dust

Particulate Fouling and Composite Fouling Assessment in Corrugated Plate Heat Exchangers

Crystallization Fouling on Different Surfaces under Static and Dynamic Experiments

Fouling During Polymerization in Different Continuous Reactor Setups

Heat Transfer and Fouling Performance During Falling Film Evaporation in Vertical Porous Tubes

Identifying fouling mechanism in a novel hybrid cooling tower's bundles: Application in concentrated solar power (CSP) plant

Advancements in Ni-P Plating Surfaces for Mitigating Crystallization Fouling in Microchannel Heat Exchangers

Experimental Research on Anti-fouling of Heat Exchanger

Analysis Of Composite Fouling In Corrugated Plate Heat Exchangers

Fouling characteristics of sintered porous surface tubes for heat exchangers in sodium chloride solution

Multi-factor analysis on thermal conductive property of metal-polymer composite microstructure heat exchanger

Experimental Study on the Interaction Between Particulate Fouling and Precipitation Fouling in the Fouling Process on Heat Transfer Tubes

Heat Exchanger Fouling and Cleaning : Fundamentals and Applications Engineering Conferences International Year 2003 Measurement and Modeling for the Mitigation of Organic Crystallization Fouling

Investigation of CaCO 3 fouling in plate heat exchangers

Experimental Characterization of a Novel Soft Polymer Heat Exchanger for Wastewater Heat Recovery

Composite Fouling Characteristics on Ni-P-PTFE Nanocomposite Surface in Corrugated Plate Heat Exchanger

Heat transfer and fouling characteristics during falling film evaporation in a vertical sintered tube