Abstract:It is well known that the electrochemical performance of spinel LiMn2O4 can be improved by Al doping. Herein, combining X-ray diffraction, Raman spectroscopy, X-ray photoelectron spectroscopy, and spherical aberration-corrected scanning transmission electron microscopy (Cs-STEM) with in situ electron-beam (E-beam) irradiation techniques, the influence of Al doping on the structural evolution and stability improvement of the LiMn2O4 cathode material is revealed. It is revealed that an appropriate concentration of Al3+ ions could dope into the spinel structure to form a more stable LiAlxMn2–xO4 phase framework, which can effectively stabilize the surface and bulk structure by inhibiting the dissolution of Mn ions during cycling. The optimized LiAl0.05Mn1.95O4 sample exhibits a superior capacity retention ratio of 80% after 1000 cycles at 10 C (1 C = 148 mA h g–1) in the voltage range of 3.0–4.5 V, which possesses an initial discharge capacity of 90.3 mA h g–1. Compared with the undoped LiMn2O4 sample, the Al-doped sample also shows superior rate performance, especially the capacity recovery performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c11315.Rietveld analysis, SEM images and elemental mapping of LiAlxMn2–xO4, corresponding FFT patterns of the HAADF images, variations and fitting curves between Z′ and ω–0.5 in LiMn2O4 and LiAl0.05Mn1.95O4, HAADF images and EDS quantitative results of LiMn2O4 and LiAl0.05Mn1.95O4 samples before and after 1000 cycles at 10 C, thickness distribution results by EELS measurements of LiMn2O4 and LiAl0.05Mn1.95O4 samples, and results obtained from the Rietveld analysis and XPS fitting parameters (PDF)This article has not yet been cited by other publications.

Improvement of the High-Performance Al-Doped LiNi1/3Co1/3Mn1/3O2 Cathode Material for New Electro-Optical Conversion Devices

Enhancing high-voltage performances of nickel-based cathode material via aluminum and progressive concentration gradient modification

Synthesis of LiNiO2 cathode materials with homogeneous Al doping at the atomic level

Enhanced Electrochemical Property of Li1.2−xNaxMn0.54Ni0.13Co0.13O2 Cathode Material for the New Optoelectronic Devices

First-Principles Investigation on Electrochemical Performance of Na-Doped LiNi1/3Co1/3Mn1/3O2

Influence of Al doping on the structure and electrochemical performance of the Co-free LiNi 0.8 Mn 0.2 O 2 cathode material

Mitigation of Cation Mixing of LiNiO2-based Cathode Materials by Li-doping for High-Performing Lithium-Ion Battery

Role of Al-doping with Different Sites Upon the Structure and Electrochemical Performance of Spherical LiNi0.5Mn1.5O4 Cathode Materials for Lithium-Ion Batteries

Effects of Al doping on the electrochemical performances of LiNi0.83Co0.12Mn0.05O2 prepared by coprecipitation

First-Principles Calculations of the Atomic Structure and Electronic Structure of F-Doped Li(Ni0.8Co0.1Mn0.1)O2 Cathode Material for Lithium-Ion Batteries

Understanding the Effect of Al Doping on the Electrochemical Performance Improvement of the LiMn 2 O 4 Cathode Material

Enhanced Rate Performance of Al-Doped Li-Rich Layered Cathode Material Via Nucleation and Post-solvothermal Method

Enhanced Electrochemical Performance of 0 . 4 Li 2 MnO 3-0 . 6

Improvement of High-Voltage Cycling Behavior of Li(Ni1/3Co1/3Mn1/3)O2 Cathodes by Mg, Cr, and Al Substitution

Improving Structure and Electrochemical Performance of Single-Crystal Ni-Rich Cathodes by Aluminium Doping

Structural and Electrochemical Characteristics of Co and Al Co-Doped Lithium Nickelate Cathode Materials for Lithium-Ion Batteries

An In-Depth Understanding of the Effect of Aluminum Doping in High-Nickel Cathodes for Lithium-Ion Batteries

LiNbO3 Coating and F- Doping Stabilize the Crystal Structure and Ameliorate the Interface of LiNi0.88Co0.06Mn0.03Al0.03O2 to Improve the Electrochemical Properties and Safety Capability

Enhanced electrochemical performances of Li2MnO3 cathode materials by Al doping

High-rate Performance of LiNi0.5Mn1.45Al0.05O4 Cathode Material for Lithium-Ion Batteries

Effects of Al and Co doping on the structural stability and high temperature cycling performance of LiNi0.5Mn1.5O4 spinel cathode materials