Abstract:This study aims at introducing the back stress of anisotropic strain-hardening into the crystal plasticity theory and demonstrating the rationality of this crystal plasticity model to describe the evolution of the subsequent yield surface of polycrystalline aluminum at the mesoscopic scale under complex pre-cyclic loading paths. By using two different scale finite element models, namely a global finite element model (GFEM) as the same size of the thin-walled tube specimen used in the experiments and a 3D cubic polycrystalline aggregate representative volume element (RVE) model, the evolution of the subsequent yield surface for different unloading cases after 30 pre-cycles is further performed by experiments and numerical simulations within a crystal plasticity finite element (CPFE) frame. Results show that the size and shape of the subsequent yield surfaces are extremely sensitive to the chosen offset strain and the pre-cyclic loading direction, which present pronounced anisotropic hardening through a translation and a distortion of the yield surface characterized by the obvious "sharp corner" in the pre-deformation direction and "flat" in the reverse direction by the definition of small offset strain, while the subsequent yield surface exhibits isotropic hardening reflected by the von Mises circle to be distorted into an ellipse by the definition of large offset strain. In addition, the heterogeneous properties of equivalent plastic strain increment are further discussed under different offset strain conditions. Modeling results from this study show that the heterogeneity of plastic deformation decreases as a law of fraction exponential function with the increasing offset strain. The above analysis indicates that anisotropic hardening of the yield surface is correlated with heterogeneous deformation caused by crystal microstructure and crystal slip. The crystal plasticity model based on the above microscopic mechanism can accurately capture the directional hardening features of the yield surface.

A quantitative study of the effect of surface texture on plasticity induced surface roughness and dislocation density of crystalline materials

Deformation-Induced Surface Roughening of an Aluminum–Magnesium Alloy: Experimental Characterization and Crystal Plasticity Modeling

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

Discrete Dislocation Dynamics Simulations of Surface Induced Size Effects in Plasticity

Investigation of Grain Boundary and Orientation Effects in Polycrystalline Metals by a Dislocation-Based Crystal Plasticity Model

A dislocation-density-based crystal plasticity model for FCC nanocrystalline metals incorporating thermally-activated depinning from grain boundaries

In-situ EBSD Study of the Active Slip Systems and Lattice Rotation Behavior of Surface Grains in Aluminum Alloy During Tensile Deformation

Grain size dependent microstructure and texture evolution during dynamic deformation of nanocrystalline face-centered cubic materials

Polycrystal Simulation of Texture-Induced Grain Coarsening during Severe Plastic Deformation

Experimental and numerical investigations of anisotropic plasticity response in polycrystalline copper by nanoindentation

Research Status of Surface Roughening during Plastic Deformation

Microplasticity and yielding in crystals with heterogeneous dislocation distribution

Polycrystal plasticity with grain boundary evolution: A numerically efficient dislocation-based diffuse-interface model

Numerical simulation technology based on crystal plasticity theory

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

Simulation of bicrystal deformation including grain boundary effects: Atomistic computations and crystal plasticity finite element analysis

Investigating the origin of cube texture during static recrystallization of fcc metals : A full field crystal plasticity-phase field study

Quantitative Investigations on Dislocation Based Discrete-Continuous Model of Crystal Plasticity at Submicron Scale

Investigation of Yield Surfaces Evolution for Polycrystalline Aluminum after Pre-Cyclic Loading by Experiment and Crystal Plasticity Simulation

On the evolution of surface roughness during deformation of polycrystalline aluminum alloys

Unveiling orientation dependence of anisotropic plasticity in polycrystalline copper by nanoindentation