4223 - ANALYSIS ON CYCLIC PLASTICITY AND STRESS DISTRIBUTION OF POLYCRYSTAL AT GRAIN LEVEL
k s zhang,hang yu,x geng,yuhcherng guo,d q li,geer zhang
2013-01-01
Abstract:To investigate the macroscopic and microscopic mechanical behavior of polycrystalline materials under the conditions of cyclic loading, a Voronoi polycrystalline aggregation model was employed to study the statistical distribution of stress and strain, and macroscopic cyclic plasticity, for a copper polycrystalline material. The algorithm for solving the visco-plastic constitutive relations that describing the slipping plasticity for single crystal grain of the polycrystalline material applied in the present paper was suggested by Zhang et al. (2004a, 2004b), in which the Cauchy stress tensor is taken as the basic variable to be solved by Newton-Raphson iterations. On the basis of calculation of single crystal constitutive equations, the simulation for a FCC copper polycrystal were carried out under the cyclic loading of symmetrical tensile and compression. According to the results, the distribution of microscopic stress, strain and effective plastic strain, and coefficient of variation (the ratio of the standard deviation to the mean) were analyzed, which shows the heterogeneities of microscopic stress and strain in the Voronoi polycrystal tessellation caused by the randomness of the grain crystals in the polycrystal aggregate. Meanwhile, the curve of mean stress and strain for the Voronoi polycrystalline tessellation were also calculated, the results can reasonably describe the Bauschinger effect and cyclic hardening characteristic of polycrystalline materials. It is necessary to point out that, in the present paper, the cyclic characteristic of polycrystalline material is not set prior. The cyclic plasticity of the Voronoi tessellation is completely obtained from the results modeled by the tessellation associated with the known mechanical behavior of a single crystal, under the cyclic load condition.