REDUCTION BY SONICATION OF EXCESS SLUDGE PRODUCTION IN A CONVENTIONAL ACTIVATED SLUDGE SYSTEM: CONTINUOUS FLOW AND LAB‐SCALE REACTOR

S. Vaxelaire,E. Gonze,G. Merlin,Y. Gonthier
DOI: https://doi.org/10.1080/09593330802379649
IF: 3.475
2008-12-01
Environmental Technology
Abstract:Conventional activated sludge wastewater treatment plants currently produce a large quantity of excess sludge. To reduce this sludge production and to improve sludge characteristics in view of their subsequent elimination, an ultrasonic cell disintegration process was studied. In a lab-scale continuous flow pilot plant, part of the return sludge was sonicated by low-frequency and high-powered ultrasound and then recycled to the aeration tank. Two parallel lines were used: one as a control and the other as an assay with ultrasonic treatment. The reactors were continuously fed with synthetic domestic wastewater with a COD (chemical oxygen demand) of approximately 0.5 g l(-) corresponding to a daily load of 0.35-0.50 kg COD kg(-1) TS d(-1). Removal efficiencies (carbon, particles), excess sludge production and sludge characteristics (particle size distribution, mineralization, respiration rate, biological component) were measured every day during the 56-day experiment. This study showed that whilst organic removal efficiency did not deteriorate, excess sludge production was decreased by about 25-30% by an ultrasonic treatment. Several hypotheses are advanced: (i) the treatment made a part of the organic matter soluble as a consequence of the floc disintegration, and optimised the conversion of the carbonaceous pollutants into carbon dioxide and (ii) the treatment modified the physical characteristics of sludge by a mechanical effect: floc size was reduced, increasing the exchange surface and sludge activity. The originality of this study is that experiments were conducted in a continuous-flow activated sludge reactor rather than in a batch reactor.
environmental sciences
What problem does this paper attempt to address?