Abstract:Wire Arc Additive Manufacturing (WAAM) technology, known for its low equipment and material costs, high material utilization, and high production efficiency, has found extensive applications in the fabrication of key components for the aerospace and aviation industries. The stability of the arc is crucial for the WAAM process as it directly affects the forming of the parts. In this study, the monitoring data of electrical signals and arc morphology during the WAAM process of 2319 aluminum alloy were investigated using a high-speed camera system and current/voltage acquisition system. By analyzing the current and voltage signals, as well as the arc imaging results, the influence of arc stability on the forming of the cladding layer was studied. The experimental results indicated that when both current and voltage exhibit regular periodic fluctuations, this manifests as a stable short-circuit droplet transition form, while sudden changes in these signals represent abnormal droplet transition forms. The adaptability of the process directly influenced the arc shape, thereby affecting the forming of the cladding layer. Under the process parameters of welding speed of 240 cm/min and wire feeding speed of 6.5 m/min, it was observed that the current signal exhibited a tight state and the variance of the arc width was minimized. This indicated that at a higher wire feeding speed, the droplet transfer frequency was increased. Under these process parameters, the arc output was more stable, resulting in a uniform metal coating.

Arc length identification based on arc acoustic signals in GTA-WAAM process

Monitoring process stability in GTA additive manufacturing based on vision sensing of arc length

A Theoretical Model of Arc Light Radiation Based on GTA Spectral Diagnosis

Impact of Process Parameters on Forming Quality and Deposition Efficiency of Unsupported Rods in Wire Arc Additive Manufacturing

Arc length stable method of GTAW based on adaptive Kalman filter

Identification of the Space Posture of Arc Welding Guns with Rotational Arc Sensors in GMAW

Arc voltage measurements for height control in pulsed arc additive manufacturing

Detection of the contact tube to working distance in wire and arc additive manufacturing

Research on Arc Length Tracking Control Technology of Tube-Sheet Welding Based on Pulsed TIG

Open source arc analyzer: Multi-sensor monitoring of wire arc additive manufacturing

Investigation of Arc Stability in Wire Arc Additive Manufacturing of 2319 Aluminum Alloy

Feature Extraction and Dimensionality Reduction of Arc Sound under Typical Penetration Status in Metal Inert Gas Welding

Layer width control in robotic pulsed gas tungsten arc additive manufacturing through composite sensing of vision and arc

Classification of Transfer Modes in Gas Metal Arc Welding Using Acoustic Signal Analysis

Power-arc model based adaptive arc length control of P-GMAW for Al–Mg alloy

Feasibility analysis of standing wave ultrasonic - Axial magnetic field hybrid for controlling GTAW arc characteristics

Feature Extraction of Arc Sound Signal in MIG Welding Based on Linear Prediction Analysis

A Real-Time Monitoring Method for Droplet Transfer Frequency in Wire-Filled GTAW Based on Arc Sensing

Fundamental study of the quality measurement for wire arc additive manufacturing process by laser ultrasonic technique

Electric Arc Length Control of Circular Seam in Welding Robot Based on Arc Voltage Sensing

Coordinated monitoring and control method of deposited layer width and reinforcement in WAAM process