Abstract:In the direct laser deposition (DLD) process, it is common to employ constant processing parameters. The utilization of the constant parameters may lead to fluctuations in the dynamic evolution of the molten pool, primarily due to the intricate thermal effects involved, which will significantly impact the processing quality. To address this issue, this study proposed a closed-loop control approach that effectively modifies processing parameters in real time by targeting on the molten pool transient area. The type of the laser used in this study is a flat-top beam. Laser power, powder feeder rate, and scanning speed are the input variables of the study to control molten pool, considering the manufacturing system. The most suitable processing parameter to control the molten pool area was found to be the laser power by a set of orthogonal experiments, with a correlation coefficient of 0.706, and significance level of 0.002. Then, the dynamic response relationship between laser power and the molten pool area was mathematically characterized by a third-order transfer function model to simplify the complex physical model of the DLD process. Subsequently, a PID controller with a filtering coefficient and anti-windup compensation was chosen compared with the other controller. In the validation experiments, it was observed that the closed-loop processing group demonstrated improved stability in maintaining the molten pool transient area, with a notable decrease of 33.7% in variability compared to the open-loop processing group. As a result, the deposited layer of the closed-loop processing group exhibited a much more satisfying surface quality and heat affect zone than the open-loop group. This study established a third-order mathematical model of the dynamic molten pool and realized the optimization of deposition quality by controlling the molten pool transient area with an enhanced PID controller, providing a fundamental basis for improving the consistency of the direct laser deposition processing quality through the implementation of real-time feedback control of molten pool physics.

Layer width control in robotic pulsed gas tungsten arc additive manufacturing through composite sensing of vision and arc

Feedback control of variable width in gas metal arc-based additive manufacturing

Monitoring process stability in GTA additive manufacturing based on vision sensing of arc length

Arc voltage measurements for height control in pulsed arc additive manufacturing

Forming Control via Interval Width in Directed Energy Deposition-Arc Process

Detection and control of layer width in fused plus wire arc additive manufacturing

Closed-loop Control of Medium-Thickness Plate Arc Welding Based on Weld-Face Vision Sensing

Active disturbance rejection control of layer width in wire arc additive manufacturing based on deep learning

Robotic Wire Arc Additive Manufacturing with Variable Height Layers

Ti6A14V Laser Alloying Process Control by Using a Self-Organizing Fuzzy Controller

Control-Oriented Modeling and Layer-to-Layer Spatial Control of Powder Bed Fusion Processes

Coordinated monitoring and control method of deposited layer width and reinforcement in WAAM process

Detection of the contact tube to working distance in wire and arc additive manufacturing

Layer-to-Layer Melt Pool Control in Laser Powder Bed Fusion

Adaptive Fuzzy Sliding-Mode Control for the Ti6al4v Laser Alloying Process

In-situ Controller Autotuning by Bayesian Optimization for Closed-loop Feedback Control of Laser Powder Bed Fusion Process

Arc length identification based on arc acoustic signals in GTA-WAAM process

Real-time monitoring and control of porosity defects during arc welding of aluminum alloys

Vision Sensing and Feedback Control of Weld Penetration in Helium Arc Welding Process

Real-time closed-loop control of molten pool transient area in direct laser deposition via PID algorithm with enhanced robustness

Penetration Control of GTAW Process for Aluminum Alloy Using Vision Sensing