Abstract:<p>Sn58-xBi-xAl-xZn were prepared by adding different addition (x = 0, 1.0, 2.0, and 3.0 wt%) of Al and Zn, and their response to melting point, microstructure, phase structure and mechanical properties were investigated. The presence of Sn-Bi-Zn eutectic significantly reduces the melting point of the alloy, but the heat fusion is increased with the increase of Zn and Al addition. The Al element is dispersed in the SnBi eutectic matrix in the form of dendritic Al-rich phase, and the Zn element is dispersed in the form of needle-like Zn-rich phase. Besides, the addition of Al and Zn leads to the refinement of the eutectic structure and the reduction of the interlaminar spacing. The Al, Zn, and Bi can be dissolved in Sn to form β-Sn phase. The competition of Al, Zn, and Bi solubilizes in Sn results in the diffraction peak of the alloy to shift. The doping of Al and Zn in Sn causes the diffraction peak of the alloy to shift to the right, but when the proportion of Bi solubilizes in Sn increases, the diffraction peak of the alloy shifts to the left. The phase interface of Sn and Bi is the non-coherent interface. The mismatch degrees between (200) Sn and (10<span class="math"><math>2¯</math></span>) Bi is 27.5%. The liquid metal induced embrittlement (LMIE) phenomenon can be observed between Al grain and Sn phase, which leads to brittle fracture of Al grains. With the increase of Al and Zn content, the mechanical properties are significantly improved. When the Al and Zn addition reaches 2 wt%, the ultimate tensile strength (UTS) of Sn56Bi2Al2Zn reaches 68.5 MPa, while the elongation reaches 49.04%, which is 22.76% and 46.34% higher than that of Sn58Bi. However, when the Al and Zn addition reaches 3 wt%, the Sn56Bi3Al3Zn possess the best UTS (70.5 MPa), but the plasticity is reduced to 26.80%. Moreover, the macroscopic hardness of Sn55Bi3Al3Zn is 25.3 HV, which is 22.2% higher than that of Sn58Bi (20.7 HV). Results show that the endogenous Al and Zn phases plays an important role in the mechanical properties of Sn58Bi.</p>

Physicochemical processes at the boundary between some semiconducting solid solutions and contact alloys

Thermodynamic Properties and Phase Equilibria of Sn–Bi–Zn Ternary Alloys

Interfacial Reactions in the Sn-Bi/Te Couples

Thermal Conductivity of Three-Dimensional Nanostructured Bi85sb15 Solid Solution

Phase Structure Analysis of AgCd and AgSn Alloy Powders

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Interfacial Reactions in Ni/Se-90 At.%te and Ni/Pb1-xSnxSe Couples

Thermoelectric Properties of Single Crystals of a Pb-Enriched Pb0.75Sn0.25Te Solid Solution

Deformation mechanism of various Sn-xBi alloys under tensile tests

Reaction evolution and alternating layer formation in Sn/(Bi0.25Sb0.75)2Te3 and Sn/Sb2Te3 couples

B-site substitutions and phase transitions in solid solutions on the base of (Na0.5Bi0.5)TiO3

Interfacial Reactions between Sn-Based Solders and n-Type Bi2(Te,Se)3 Thermoelectric Material

Effects of endogenous Al and Zn phases on mechanical properties of Sn58Bi eutectic alloy

Phase Equilibria and Solidification of Ternary Sn–Bi–Ag Alloys

Interfacial Stability in Bi2Te3 Thermoelectric Joints

Non-Equilibrium Crystallization of Monotectic Zn-25%Bi Alloy under 600 g

SYNTHESIS OF ALLOYS OF THE Sb2Se3-CuCr2Te4 SYSTEM AND PHYSICO-CHEMICAL PROPERTIES

Atomic-Resolution Interfacial Reaction Mechanism between Bi 2 Te 3 -Based Alloys and Ni Electrodes

Wetting Behavior and Interfacial Characteristics in the Molten Bi-Sn/High-Entropy Alloy System

The Effect of In Concentration and Temperature on Dissolution and Precipitation in Sn–Bi Alloys

Phase Equilibria of the Sn-Sb Binary System