Abstract:To optimize the configuration of spatial-temporal resources at intersections with mixed traffic flow of passenger cars and heavy vehicles, this paper proposes a set of mixed integer linear programming（MILP） model with aim to maximize the intersection capacity. In the model, different impacts of the locations of permitted lanes on flows of different modes and vehicle turning maneuvers are considered to increase the model applicability. The constrains on the relative setting position of permitted lanes for left-turn, through and right-turn are released. That’s to say, the permitted left-turn lanes don’t have to be on the left of the permitted through lanes, and the permitted through lanes don’t have to be on the left of the right-turn permitted lanes. This may induce some new flow conflicts（potential conflicts） and whether these conflicts exist is affected by the lane channelization scheme. Thus, some constraints are added in the model, among which one is to identify which potential conflicts are arisen with specific lane scheme, the other is to determine these conflicts’ impact on the configuration of temporal resources at intersections. The results from numerical tests show that this impact will change the configuration of spatial-temporal resources at intersections.Compared with the conventional lane-based model, the modified model can significantly improve the intersection maximum capacity while ensure safe flow propagation. The improvement on the intersection maximum capacity increases with the heavy vehicle proportions and the impact of lane location on travel efficiency. But with the increase of the difference of travel efficiencies between heavy vehicles and passenger cars, the improvement first increases and then decreases.

Performance Analysis of Parallel Flow Intersection and Displaced Left-Turn Intersection Designs

Optimizing Traffic Signal Control for Continuous-Flow Intersections: Benchmarking against a State-of-Practice Model

Analysis om waiting area for left-turn vehicles at signalized intersections

Delay Estimation and Application Conditions of Two-Legged Continuous Flow Intersection

Assessing Pedestrian and Bicycle Treatments at Complex Continuous Flow Intersections

Optimizing traffic signal control for continuous‐flow intersections: Benchmarking against a state‐of‐practice model

Introducing the concept of alternative intersections with three-phase traffic signals

Flow feasibility condition analysis and design optimization of contraflow left-turn lanes at signalized intersections based on kinematic wave theory

Traffic Design and Signal Timing of Staggered Intersections Based on a Sorting Strategy

Analysis of a Signalized Intersection with Dynamic Use of the Left-Turn Lane for Opposite through Traffic

Conflict delay models at two-phase intersection

Introducing the Super DDI as a Promising Alternative Service Interchange

Method of computing left-turn vehicle traffic capacity at two-phase intersection

Optimization of Signal Timing for the Contraflow Left-Turn Lane at Signalized Intersections Based on Delay Analysis

Operational Efficiency Evaluation of Intersections with Dynamic Lane Assignment Using Field Data

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Modelling the saturation flow rate for continuous flow intersections based on field collected data

An Approach of Transit Passive Priority with Transit Phase Overlapped at Intersection of Arterial Signal Progression

Configuration of Spatial-temporal Resources at Intersections Considering Travel Efficiencies of Mixed Flows

Increasing the Capacity of Signalized Intersections by Allocating Exit Lanes to Turning Movements

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan