Abstract:Characterization and analysis process of fracture toughness of in situ consolidation thermoplastic composite materials with automated fiber placement under different placement pressures. This study delved into the Mode I fracture behavior of laser‐assisted automated fiber placement (AFP) in situ consolidated thermoplastic composite laminates under different curing pressures. In compliance with ASTM D5528 standards, T700 carbon fiber reinforced polyether ether ketone (T700‐CF/PEEK) double cantilever beam (DCB) specimens were fabricated and segregated into three test groups subjected to distinct roller pressures: DCB‐100N, DCB‐500N, and DCB‐1500N. The fracture toughness of these specimens was then inversely characterized by employing an optimized ASTM‐based data reduction methodology. A kind of tri‐linear cohesive zone model (CZM) incorporating the fracture process zone (FPZ) length was developed to simulate delamination behavior, showing good agreement between experimental results and simulation predictions. Compared with the other two test groups, DCB‐1500N specimens have more inter‐laminar bridging fibers and higher propagated toughness. Although the length of fiber bridging area is shorter, the fiber bridging density is higher, so the influence of fiber bridging on toughness is more pronounced in the DCB‐1500N specimens. This study provides theoretical guidance for the impact resistance design of thermoplastic composites (TPCs), offering valuable insights into the intrinsic relationship between material processing and fracture damage mechanisms. Highlights Explore the characteristic interlaminar fracture behavior of thermoplastic laminates made by AFP under different curing pressures. Develop a more accurate tri‐linear CZM model to describe the plastic deformation at crack tips and fiber bridging during the delamination process. Unveil the intrinsic relationship between AFP curing pressure and ductile fracture mechanism of thermoplastic composites.

Measurements of Interface Fracture Strength between Fiber-Reinforced Composite Laminates and Thin Surface Films Using the Blister Test

Protocol to perform pressurized blister tests on thin elastic films

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

The characterization of interface adhesion of dissimilar elastic-plastic materials by a pressurized blister test modeling

Measuring the interlaminar fracture toughness of thin carbon fiber/polyamide6 composites using adhesively bonded stiffeners

Study on Mode I interlaminar fracture behavior of automated fiber placement in situ consolidation thermoplastic composite considering the influence of roller compaction pressure

Theoretical study on shaft-loaded blister test technique: Synchronous characterization of surface and interfacial mechanical properties

Fracture toughness and failure behavior of CF/epoxy composites interleaved with melt‐infused PET, PEI, and PEEK film

Analysis of energy release rate and bending-to-stretching behavior in the shaft-loaded blister test

The Dependence of the Fracture Toughness of Thermoplastic Composite Laminates on Interfacial Interaction

Fracture Toughness Micromechanics by Energy Methods With a Photocure Fiber-Reinforced Composite

Current status of blister tests for adhesion of thin films to substrate

Fracture properties of carbon/glass fiber composite laminates with surface scratch damage

Experimental Study on Compression Failure of Composite Laminates with Prefabricated Surface Cracks

Enhancing the performance of the T-peel test for thin and flexible adhered laminates

Towards interface toughness measurement in nanometric films

Image-Based Inertial Impact Test for Composite Interlaminar Tensile Properties

Theoretical study of adhesion energy measurement for film/substrate interface using pressurized blister test: Energy release rate

Experimental investigation of trans-scale displacement responses of wrinkle defects in fiber-reinforced composite laminates

Interlaminar fracture toughness analysis of fiber reinforced metal laminates based on APDL