Abstract:Concrete reinforcement is essential for ensuring the safety and durability of concrete structures. Bonding steel plates to reinforce concrete is widely used to renovate or strengthen concrete beam structures. Due to construction quality and the influence of factors such as environment and fatigue, debonding often occurs between the steel plate and concrete, making monitoring and early warning after concrete structure reinforcement challenging. This paper proposes a novel approach to monitor the degree of debonding between the steel plate and concrete beam using active sensing technology. The method uses lead zirconate titanate (PZT) as an actuator to generate stress waves. It prepares strip sensors with polyvinylidene fluoride as the sensing element to monitor stress waves passing through the steel plate and concrete beam. The monitoring system detects the degree of debonding between the steel plate and the concrete beam by monitoring the change in surface voltage of the sensor. Experiments show that the degree of debonding significantly correlates with the received voltage signal; the higher the debonding, the larger the received voltage signal. It is also observed that, at the same degree of debonding, the actuator and sensor attachment position have a particular impact on the received voltage signal. Through experiments and numerical simulation analysis, it is found that when the sensor is attached to the left side of the steel plate, that is, the bonded section of the steel plate, the amplitude of the voltage signal collected by the dynamic information acquisition system is the smallest, i.e., V_debonded section > V_middle > V_bonded section. Based on the above research, the active sensing technology proposed in this paper has good sensitivity to the degree of debonding between the steel plate and concrete. It is expected to become an effective monitoring and evaluation method for the degree of debonding between steel plates and concrete.

Surface strain distribution method for delamination detection using piezoelectric actuators and sensors

Delamination assessment of a laminated composite beam using distributed piezoelectric sensor/actuator

Identifying Delamination in Carbon Fiber Composites Based on Defect Modes in Imperfect Phononic Crystals

Delamination detection in laminated composite beams using electro-mechanical impedance signatures

Vibration-Based In-Situ Detection and Quantification of Delamination in Composite Plates

Monitoring interfacial defects in a composite beam using impedance signatures

Exploration of damage detection of imperfect composite beams using high-frequency piezoelectric signatures

Assessing the effects of delamination on the damped dynamic response of composite beams with piezoelectric actuators and sensors

Experimental Investigation of Damage Detection in Composite Material Structures Using a Laser Vibrometer and Piezoelectric Actuators

Delamination Detection in Composite Plates Using Linear and Nonlinear Ultrasonic Guided Waves

Delamination Analysis of Carbon Fiber/Epoxy Composite Laminates under Different Loading Rates Using Acoustic Emission

Optimization of piezoelectric sensor location for delamination detection in composite laminates

Detecting Debonding between Steel Beam and Reinforcing CFRP Plate Using Active Sensing with Removable PZT-Based Transducers

Using d15 Piezoelectric Transducers for Ultrasonic Inspection of Delamination in Laminated Structures

Assessment of Fatigue Damage of Prefabricated Concrete Composite Beams with Piezomagnetic Signal

Delamination detection on composite laminates using the modal displacement unevenness coefficient

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

IMPACT DAMAGE DETECTION IN COMPOSITE LAMINATE PLATES USING AN INTEGRATED PIEZOELECTRIC SENSOR AND ACTUATOR COUPLE COMBINED WITH WAVELET-BASED FEATURES EXTRACTION APPROACH

Detection of Debonding Between Fiber Reinforced Polymer Bar and Concrete Structure Using Piezoceramic Transducers and Wavelet Packet Analysis

Damage Localization in Composite Laminates by Building in PZT Wafer Transducers: A Comparative Study with Surface‐Bonded PZT Strategy

Study on the monitoring method of debonding between concrete beams and reinforced steel plates based on piezoelectric smart materials