Abstract:Effective thermal conduction between solid interfaces has emerged as a major bottleneck in heat dissipating heat from new-generation high-performance electronics. Gallium-based liquid metals (LMs), known for their high thermal conductivity, are gaining significant traction as thermal interface materials (TIMs) for enhanced thermal management. In this work, to address the key issues facing the application of gallium-based LMs as TIMs, including the lack of composition ratio data, poor coating performance and the need for improved thermal conductivity, two types of gallium-based LM-TIMs (Ga-In binary LM-TIMs and Ga-In-Sn ternary LM-TIMs) with different composition ratios were experimentally prepared, investigated and optimized. The thermal conductivities of the LM-TIMs at different temperatures (80 - 120 ℃) were tested, and the application reliability of the LM-TIMs was optimized by continuously destructing the oxide layer and filling micro copper particles. The influence of optimization parameters such as the duration of the destruction of oxide layer, the filling ratios of the particles and the particle size on the operation performance of the LM-TIMs was studied and analyzed. The results showed that the LM-TIMs exhibited excellent thermal conductivities of 29.6 - 38.5 W/(m·K), and the thermal conductivity increased with indium mass fraction and decreased with tin mass fraction. Significant improvements in coating performance were observed with the increase of the duration of destructing oxide layer, but it led to a reduction in thermal conductivity. Balancing coating performance and thermal conductivity, it was found that 30 min was the ideal duration. The filling of micro particles made up for the reduced thermal conductivity, and higher filling ratios and smaller particle sizes achieved better enhancement. In the experiment, a filling ratio of 5 % was appropriate because solidification occurred in LM-TIMs at higher filling ratios which weakened the thermal conductivity. This work provided valuable reference for the application and optimization of high thermal conductive gallium-based LM-TIMs.

Development of a fast thermal response microfluidic system using liquid metal

Capillary-Based Microfluidic Fabrication of Liquid Metal Microspheres Toward Functional Microelectrodes and Photothermal Medium.

Experimental Investigation on Optimization of the Performance of Gallium-Based Liquid Metal with High Thermal Conductivity As Thermal Interface Material for Efficient Electronic Cooling

Transient Performance of a Thermal Energy Storage-Based Heat Sink Using a Liquid Metal As the Phase Change Material

Microfluidics Temperature Compensating and Monitoring Based on Liquid Metal Heat Transfer

Liquid Metal Based Miniaturized Chip-Cooling Device Driven by Electromagnetic Pump

A Performance-Enhanced Liquid Metal-Based Microheater with Parallel Ventilating Side-Channels

Liquid Metal Based Mini/Micro Channel Cooling Device

Electrically driven chip cooling device using hybrid coolants of liquid metal and aqueous solution

Design of Thermal Liquid Flow Microsensor

Recent Advancement on Liquid Metal Cooling for Thermal Management of Computer Chip

Hybrid Mini/Micro-Channel Heat Sink Using Liquid Metal and Water As Coolants

Liquid Metal Cooling in Thermal Management of Computer Chips

Design of Liquid-Metals Heating-Induced Temperature Gradient Focusing in Microfluidic Channels

Hybrid Liquid Metal–water Cooling System for Heat Dissipation of High Power Density Microdevices

Study of Thawing Behavior of Liquid Metal Used As Computer Chip Coolant

An Enhanced Heat Transfer Method Based on the Electrocapillary Effect of Gallium-Based Liquid Metal

Self-Driven Electronic Cooling Based on Thermosyphon Effect of Room Temperature Liquid Metal

Precise temperature control of microfluidic chamber for gas and liquid phase reactions

Advances in Liquid Metal Science and Technology in Chip Cooling and Thermal Management

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring