Abstract:In-situ thermal response testing (TRT) has become the most effective way to determine ground thermal parameters before developing renewable geothermal energy systems. However, these parameters may not be static when some hydrologic conditions in porous formation change with time. In this paper, we propose a method for evaluating the ground heat exchange performance using the active distributed temperature sensing (A-DTS) technology, which infers soil moisture by a thermal response caused by active electrical current. We evaluated the feasibility of this method by several lab experiments and a field thermal response test (TRT). Using this method, the relationship between thermal conductivity and soil moisture content was established for silt, clay, organic soil and sand, respectively. To quantitatively evaluate the sensitivity of soil thermal conductivity to moisture content, a new parameter called relative thermal conductivity (beta), is defined to describe the effect of water bridges among soil solid particles on thermal conductivity. The lab test results demonstrate that soil moisture content has significant influence on thermal conductivity when the soil is nearly dry (beta > beta((cri ))), but its effect becomes less evident when the soil is moist(beta <= beta((cri))). It is found that the relationship between soil moisture content and thermal conductivity can be well fitted by the Johansen model. The results of the field-scale TRT demonstrated the ability of the proposed technique to detect the effects of rainfall on soil thermal conductivity near the ground surface. The field test results also suggest that the soil thermal conductivity measured by in-situ DTS is larger than that obtained from soil samples in lab. However, for rock, the thermal conductivity acquired by DTS is less than the values collected in lab. (C) 2018 Published by Elsevier B.V.

A Method to Estimate the Hydraulic Conductivity of the Ground by TRT Analysis

Effects of groundwater flow on thermal response test of deep borehole heat exchanger

Estimation of Groundwater Flow Rate by an Actively Heated Fiber Optics Based Thermal Response Test in a Grouted Borehole

Estimation of Soil and Grout Thermal Properties for Ground-Coupled Heat Pump Systems: Development and Application

Effects by geothermal gradient on thermal response tests for boreholes

Estimation of Aquifer Transmissivity From Analysis of Long-Term Monitoring With the Thiem Solution

Sensitivity Study of Thermal Response Test Using Resistively Heated Methods under Various Setups

Estimation of Ground Thermal Properties for Coaxial BHE Through Distributed Thermal Response Test

Stratified thermal response test measurement and analysis

Evaluating an enhanced thermal response test (ETRT) with high groundwater flow

Inclusion of advection in fractures in the line source equation for analysis of thermal response tests

Investigation of the Influence of Soil Moisture on Thermal Response Tests Using Active Distributed Temperature Sensing (A–DTS) Technology

Ground Heat Exchanger Design Subject to Uncertainties Arising from Thermal Response Test Parameter Estimation

A numerical investigation to analyze the effect of changing ambient conditions on accurate and stable identification of thermal conductivity of ground source heat pump system using thermal response test

Distributed Thermal Response Multi-Source Modeling to Evaluate Heterogeneous Subsurface Properties

Determination of ground thermal properties for energy piles by thermal response tests

A Tracer Method to Determine Hydraulic Conductivity and Effective Porosity of Saturated Clays Under Low Gradients

Uncertainty Study and Sensitivity Analysis of Soil-Rock Thermal Response Test

A New Analytical Model for the Estimation of Three-phase Rock-soil Thermal Conductivity for Geothermal Utilization

Introduction of a Thermal Response Test (TRT) Apparatus Used for Measuring Underground Heat Exchanger Characteristics

A Case Study of Field Thermal Response Test and Laboratory Test Based on Distributed Optical Fiber Temperature Sensor