Abstract:There is a vast amount of globally underutilized low-grade mine tailings and leach residues, including those from primary processing of gold. In this research, the target is to recover the remaining gold (10.9 g/t) from weathered refractory iron-rich residue that had previously been subject to autoclave oxidation, subsequent cyanidation in a conventional carbon-in-leach (CIL) circuit as well as storage at tailings area. Chloride leaching has been considered as one of the most promising cyanide-free gold leaching methods and it has shown positive outcomes in treating primary gold ores, concentrates, and flotation tailings. Therefore, in the current study, the iron-rich residue investigated was subjected to chloride leaching combined with simultaneous carbon adsorption. The investigated parameters included leaching time (2–8 h), chloride concentration ( [Cl − ] = 0.2–5 M), type and concentration of oxidant ( [Cu 2+ ]/[Fe 3+ ] = 0.1–1 M), as well as type and concentration of activated carbon (14–25 g/L), whereas S/L ratio (100 g/L), acidity ( pH = 1), and temperature (90 °C) were kept constant. Leaching results indicate that up to 40% of the remaining gold could still be recovered from the investigated residue with optimized chloride leaching. According to the results, the most important parameter for gold recovery was the leaching time. Moreover, of the studied oxidants, cupric ions were shown to contribute more to gold recovery when compared to ferric ions (35% vs. 24% at [Cu 2+ ]/[Fe 3+ ] = 0.1 M). Nevertheless, an increase of cupric concentration from 0.1 M (low-concentrated) to 0.5 M, resulted in only a slight increase in gold recovery (from 36% to 40%), whereas no further improvement in gold recovery was achieved with a 1 M cupric concentration. Two studied activated carbon products showed equal effectiveness in gold adsorption. In-situ carbon adsorption was shown to occur effectively in chloride media, as all dissolved gold could be detected in the activated carbon, and the concentration of remaining gold in the pregnant leach solution was minimal (< 0.02 mg/L). These findings indicate that low-concentrated chloride leaching of leach residues from industrial gold processes can allow an enhanced recovery of gold from previously mined and treated raw materials.

Enrichment of Gold in Low Grade Copper Matte from Arsenical Refractory Gold Concentrate via Matte Smelting Method

The Recovery of Gold in Low-Grade Cyanide Tailings by Chlorination Roasting

An integrated and sustainable hydrometallurgical process for enrichment of precious metals and selective separation of copper, zinc, and lead from a roasted sand

Characteristics of Gold Minerals in Gold Concentrate with a High Copper Content and Effective Gold Recovery via Flotation and Ammonia Pretreatment–Cyanidation Leaching

Research on the Comprehensive Utilization of Cyanidation Slags of a Gold Smelter

Facile and Novel Method for the Recovery of Gold from a Calcined Concentrate Via Copper–ammonia -Thiourea System and Activated Carbon

Element Distribution in Oxygen-Enriched Bottom-Blown Smelting of High-Arsenic Copper Dross

Enrichment of valuable metals from silver tailings using the alkali roasting-leaching method

Effective Removal of Arsenic from Copper Matte by Sodium Carbonate

Rapid gold cyanidation from a sulfur-high and arsenic-high micro-fine concentrate via facile two-stage roasting pre-treatment

Enhanced Hydrometallurgical Pretreatment of Micro-disseminated Gold Ore

Method for improving adsorption capacity of gold(I) thiosulfate complex on mercapto-functionalized silica gel by masking copper with ethylenediamine

Leaching of Gold and Silver from a Complex Sulfide Concentrate in Copper-Tartrate-Thiosulfate Solutions

Gold recovery from cyanidation residue by chloride leaching and carbon adsorption – Preliminary results from CICL process

Recovery of copper from refining slags of copper fire anode furnace by waste acid leaching and CaO roasting process

Study on the occurrence characteristics of arsenic in copper matte

One step to direct extracted gold and silver from industrial Cu-Ag-Sb-Au alloy by a convenient bimetallic electrolytic separation process

Recovery of valuable metals from mining and mineral processing waste

Recovery of high-grade copper matte by selective sulfurization of CuO–Fe2O3–SiO2–CaO system

A green method to clean copper slag and rapidly recover copper resources via reduction-sulfurizing smelting and super-gravity separation at low temperature

Study on Synergistic Strengthening of Gold Extraction with Copper Ethylenediamine Thiosulfate Using Pyrite and Nickel Ions