Abstract:Ammonia is harmful to human health, however, the detection limit of the sensor based on traditional semiconductor gas sensors is high and the speed is slow. Constructing heterostructure is an effective method to improve the performance of sensors. In this article, 1-D MoO3 nanorods and SnO2 nanoparticles are successfully combined to obtain MoO3/SnO2 nanocomposite. The 1-D structure can increase the speed of electron transport, while the nanoparticles on the surface increase the specific surface area, more importantly, the structure maximizes the interface area between the two materials which can transfer electronic more efficiently. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HRTEM), selected area electron diffraction (SAED), energy dispersive spectrometer (EDS), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET), and Barrett–Joyner–Halenda (BJH) are used to analyze the microstructure and elemental composition of MoO3/SnO2. The diameter of MoO3/SnO2 nanocomposite is approximately 200 nm and the distribution is uniform. The response of MoO3/SnO2 nanocomposite to 100-ppm NH3 is 12.7 at 280 °C, and the response/recovery time is 13/2 s. The detection limit for NH3 can reach 10 ppb (response 1.3), which enables rapid detection of NH3 at low concentration. Electron transport requires more energy to overcome the contact barrier between pure SnO2 nanoparticles, which can also lead to electron emission and noise increase. However, the sensitive electrons of MoO3/SnO2 nanocomposite can transmit electrons along the 1-D rod-like structure of MoO3, which undoubtedly accelerates the efficiency of electron transmission. Moreover, n-n heterojunction formed between MoO3 and SnO2 to bend the SnO2 band and show better sensitivity to NH3. Therefore, MoO3/SnO2 nanocomposite shows a low detection limit and a rapid response/recovery speed. Nevertheless, the nanoparticles on the surface of MoO3/SnO2 nanocomposite begin to agglomerate with the increase of SnO2 content, which leads to the decrease of gas-sensitive response. The formation process of MoO3/SnO2 composites is also discussed in this article. The excellent gas sensing results show that MoO3/SnO2 composites are a promising gas sensing material.

Room-temperature high-performance ammonia gas sensor based on layer-by-layer self-assembled molybdenum disulfide/zinc oxide nanocomposite film

Ammonia sensing properties of metal–organic frameworks-derived zinc oxide/reduced graphene oxide nanocomposite

Suspended SnS2 Layers by Light Assistance for Ultrasensitive Ammonia Detection at Room Temperature

MXene/MoS 2 nanosheet/polypyrrole for high-sensitivity detection of ammonia gas at room temperature

High-performance Ammonia Sensor at Room Temperature Based on 2D Conductive MOF Cu3(HITP)2

A selective NH3 gas sensor based on Fe2O3–ZnO nanocomposites at room temperature

High Performance Gas Sensors Based on In-Situ Fabricated ZnO/polyaniline Nanocomposite: the Effect of Morphology on the Sensing Properties

Pt/MoS2/Polyaniline Nanocomposite as a Highly Effective Room Temperature Flexible Gas Sensor for Ammonia Detection

Ammonia Sensing Performance at Room Temperature of Ca-Doped CNFs/Al2O3 Gas Sensor

3D substoichiometric MoO3−x/EGaln framework for room temperature NH3 gas sensing

Preparation of MoS2 Nanospheres using a Hydrothermal Method and Their Application as Ammonia Gas Sensors Based on Delay Line Surface Acoustic Wave Devices

MoO 3 /SnO 2 Nanocomposite-Based Gas Sensor for Rapid Detection of Ammonia

TiO2-modified MoS2 monolayer films enable sensitive NH3 sensing at room temperature

Chemical spray pyrolysis deposited ZnO/ZIF-8 and cobalt doped ZnO/ZIF-8 composite thin films for highly sensitive and selective ammonia sensing at room temperature

Imparting hydrophobicity to a MOF on layered MXene for the selective, rapid, and ppb level humidity-independent detection of NH3 at room temperature

2D/2D Dy 2 O 3 Nanosheet/MoO 3 Nanoflake Heterostructures for Humidity-Independent and Sensitive Ammonia Detection

Ti3C2Tx MXene-SnO2 nanocomposite for superior room temperature ammonia gas sensor

Surface Enhancement Effects of Tiny SnO2 Nanoparticle Modification on Α-Fe2o3 for Room-Temperature NH3 Sensing.

Preparation and study of ammonia gas sensor based on ZnO/CuO heterojunction with high performance at room temperature

Graphene Oxide-Coated Mach-Zehnder Interferometer Based Ammonia Gas Sensor

PEDOT/flower-like 1 T-2H MoS2/nitrogen-doped graphene ternary nanocomposite for efficient room temperature real-time monitoring of ammonia