Abstract:Because of the shortage of natural rutile, synthetic rutile is a widely used substitute welding materials for natural rutile owing to its excellent mechanical and thermal properties. In this work, rutile TiO2 was prepared from oxidation roasting titanium slag, which can be used as special welding materials. The phase microstructure characteristics of the raw materials and the roasted samples were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM) and Fourier-transform infrared (FT-IR) spectroscopic analysis. Results indicated that the contents of sulfur (S) and carbon (C) in titanium slag decreased during oxidation roasting process, and the decreases of sulfur and carbon contents were mainly ascribed to the formation of corresponding oxides. XRD and FT-IR results revealed the formation of rutile TiO2 phase after titanium slag through oxidization roasting; additionally, observed from SEM patterns, the rutile TiO2 phase with a complex short rod-like crystal appeared in the products. Since the contents of sulfur (S), phosphorus (P) and carbon (C) element were all below 0.030% in the prepared rutile TiO2 with the recommended roasting approach (roasted at 1100 °C for 120 min), the present work highlights that Panzhihua titanium slag is a potential resource of titanium for the manufacture of high-quality rutile TiO2 applicable for special welding materials industry.

Study of the oxygen reduction of low valent titanium in high titanium slag by microwave rapid heating

Preparation of synthetic rutile from high titanium slag using microwave heating

Multi-scale investigation of the formation and properties of high-grade rutile TiO2 from titanium slags using microwave heating

Evaluation of the structure and valence state of titanium oxide in titania slag under microwave heating

An investigation of phase transformation of titania slag using microwave heating

Microwave-assisted preparation of nanocluster rutile TiO2 from titanium slag by NaOH-KOH mixture activation

Effects of mechanical activation on structural and microwave absorbing characteristics of high titanium slag

Investigation on drying characteristics of high titanium slag using microwave heating

Highly efficient oxidation of Panzhihua titanium slag for manufacturing welding grade rutile titanium dioxide

Selective enrichment and extraction of well-catalyzed perovskites on melting-microwave heating process from blast furnace slag

Preparation of rutile titanium dioxide pigment from low-grade titanium slag pretreated by the NaOH molten salt method

Phase transition kinetics and strengthening mechanism of rutile TiO2 prepared by microwave-enhanced calcination of TiC-doped metatitanic acid

Thermal transformations of titanium slag of high titania content

A novel preparation of titanium dioxide from titanium slag

Electrosynthesis of Titanium from High-Titanium Slag with Short-Process in Molten CaCl2

A process for producing synthetic rutile from Panzhihua titanium slag

Accelerated sintering and phase transformation of TiO2in microwave radiation

Recovery of titania from high titanium slag by roasting method using concentrated sulfuric acid

Accelerated sintering and phase transformation of TiO 2 in microwave radiation

Simultaneous removal of Cr(III) and V(V) and enhanced synthesis of high-grade rutile TiO2 based on sodium carbonate decomposition

A Facile Microwaving Method to Turn Titanium Oxide into Highly Active Ti3+ Self-Doped Structure