Abstract:Distributed fiber-optic sensing (DFOS) technologies have been used for decades to detect damage in infrastructure. One recent DFOS technology, Optical Frequency Domain Reflectometry (OFDR), has attracted attention from the structural engineering community because its high spatial resolution and refined accuracy could enable new monitoring possibilities and new insight regarding the behavior of reinforced concrete (RC) structures. The current research project explores the ability and potential of OFDR to measure distributed strain in RC structures through laboratory tests on an innovative beam–column connection, in which a partial slot joint was introduced between the beam and the column to control damage. In the test specimen, fiber-optic cables were embedded in both the steel reinforcement and concrete. The specimen was tested under quasi-static cyclic loading with increasing displacement demand at the structural laboratory of the Pacific Earthquake Engineering Research (PEER) Center of UC Berkeley. Different types of fiber-optic cables were embedded both in the concrete and the rebar. The influence of the cable coating and cable position are discussed. The DFOS results are compared with traditional measurements (DIC and LVDT). The high resolution of DFOS at small deformations provides new insights regarding the mechanical behavior of the slotted RC beam–column connection, including direct measurement of beam curvature, rebar deformation, and slot opening and closing. A major contribution of this work is the quantification of the performance and limitations of the DFOS system under large cyclic strains. Performance is quantified in terms of non-valid points (which occur in large strains when the DFOS analyzer does not return a strain value), maximum strain that can be reliably measured, crack width that causes cable rupture, and the effect of the cable coating on the measurements. Structural damage indices are also proposed based on the DFOS results. These damage indices correlate reasonably well with the maximum sustained drift, indicating the potential of using DFOS for RC structural damage assessment. The experimental data set is made publicly available.

Experimental strain modal analysis for beam-like structure by using distributed fiber optics and its damage detection

Modal Strain Energy-Based Model Updating Method for Damage Identification on Beam-Like Structures

A Strain Modal Flexibility Method to Multiple Slight Damage Localization Combined with a Data Fusion Technique

Structural Identification and Damage Detection Through Long-Gauge Strain Measurements

Experimental Investigation On Structural Damage Detection Scheme Based On Distributed Fiber Optic Sensors

Modal Analysis on Macro-strain Measurements from Distributed Long-gage Fiber Optic Sensors

Damage modes detection of composite laminates using improved modal strain energy method

A Model‐free Method for Damage Locating and Quantifying in a Beam‐like Structure Based on Dynamic Distributed Strain Measurements

Two-Level Damage Detection Strategy Based on Modal Parameters from Distributed Dynamic Macro-Strain Measurements

Improvement Of Typical Damage Identification Techniques Using Dynamic Strain Distribution From Long-Gage Fbg Sensors

Deformation measurement based on high resolution distributed optical fiber sensing and conjugated beam method

An Experimental Study on Damage Detection of Structures Using a Timber Beam

Damage Localisation and Severity Evaluation of a Beam-Like Timber Structure Based on Modal Strain Energy and Flexibility Approaches

Damage Identification Research on Beam Structures by Integrating Multiple Modal Parameters

Quasi-Static Macrostrain-Based Structural Damage Detection With Distributed Long-Gauge Fiber Bragg Grating Sensing

Structural Damage Detection Based on Structural Macro-Strain Mode Shapes Extracted From Non-Stationary Output Responses

Modal Analysis Based on Distributed Strain Measurements:Theory and Application

Experimental investigations on a laboratory timber bridge using Damage Index Method for plate-like structures

An improved conjugated beam method for structural deformation monitoring based on distributed optical fiber strain sensing technique

Strain mode based damage identification and location for thin-walled structure

Distributed Fiber-Optic Strain Sensing of an Innovative Reinforced Concrete Beam–Column Connection