Abstract:Distributed fiber-optic sensing (DFOS) technologies have been used for decades to detect damage in infrastructure. One recent DFOS technology, Optical Frequency Domain Reflectometry (OFDR), has attracted attention from the structural engineering community because its high spatial resolution and refined accuracy could enable new monitoring possibilities and new insight regarding the behavior of reinforced concrete (RC) structures. The current research project explores the ability and potential of OFDR to measure distributed strain in RC structures through laboratory tests on an innovative beam–column connection, in which a partial slot joint was introduced between the beam and the column to control damage. In the test specimen, fiber-optic cables were embedded in both the steel reinforcement and concrete. The specimen was tested under quasi-static cyclic loading with increasing displacement demand at the structural laboratory of the Pacific Earthquake Engineering Research (PEER) Center of UC Berkeley. Different types of fiber-optic cables were embedded both in the concrete and the rebar. The influence of the cable coating and cable position are discussed. The DFOS results are compared with traditional measurements (DIC and LVDT). The high resolution of DFOS at small deformations provides new insights regarding the mechanical behavior of the slotted RC beam–column connection, including direct measurement of beam curvature, rebar deformation, and slot opening and closing. A major contribution of this work is the quantification of the performance and limitations of the DFOS system under large cyclic strains. Performance is quantified in terms of non-valid points (which occur in large strains when the DFOS analyzer does not return a strain value), maximum strain that can be reliably measured, crack width that causes cable rupture, and the effect of the cable coating on the measurements. Structural damage indices are also proposed based on the DFOS results. These damage indices correlate reasonably well with the maximum sustained drift, indicating the potential of using DFOS for RC structural damage assessment. The experimental data set is made publicly available.

The strain field method for structural damage identification using Brillouin optical fiber sensing

FBG sensor based dynamic monitoring and analysis on sliding construction of a Prestressed Reticulated Shell-String structure

A Novel Method of Embedding Distributed Optical Fiber Sensors for Structural Health Monitoring

Distributed fiber optic strain sensing for crack detection with Brillouin shift spectrum back analysis

Brillouin scattering spectrum-based crack measurement using distributed fiber optic sensing

A Strain Modal Flexibility Method to Multiple Slight Damage Localization Combined with a Data Fusion Technique

The study on prestressed cable stress based on Brillouin-optictime optic fiber sensor

Study on Real-Time Reinforcement Stress Measurement Based on Brillouin Optical Time Domain Analysis

Real-time strain monitoring and control of urban bridge cluster monitoring system with FBG sensor

Structural Damage Detection Based on Structural Macro-Strain Mode Shapes Extracted From Non-Stationary Output Responses

Experimental strain modal analysis for beam-like structure by using distributed fiber optics and its damage detection

Application of a Distributed Optical Fiber Sensing Technique in Monitoring the Stress of Precast Piles

Application of Optical-Fiber Sensing to Concrete Support and Continuous Wall Strain Monitoring

A novel damage detection method for carbon fibre reinforced polymer structures based on distributed strain measurements with fibre optical sensor

Distributed Fiber-Optic Strain Sensing of an Innovative Reinforced Concrete Beam–Column Connection

Distributed fiber optic sensing for internal strain monitoring in full life cycle of concrete slabs with BOFDA technology

Deformation measurement based on high resolution distributed optical fiber sensing and conjugated beam method

Complex Deformation Monitoring of Shield Tunnel Segment Joints Using Distributed Fiber Optic Sensing Technology: Experimental Verification

Multiple Damage Detection Techniques By Dynamic Strain Measurements Using Fbg Sensors

Quantitative strain measurement and crack detection in RC structures using a truly distributed fiber optic sensing system

Performances of Distributed Fiber Optic Strain Sensor with Thin-Walled Ring