Mechanical, rheological, and carbon dioxide barrier properties of polyvinylidene fluoride/TiO2 composites for flexible riser applications
Jihong Wen,Yi Cui,Dong Huang,Yan Li,Xichong Yu,Xinpeng Zhang,Xiaoyu Meng,Qiong Zhou
DOI: https://doi.org/10.1002/app.52897
IF: 3
2022-07-28
Journal of Applied Polymer Science
Abstract:Surface modification of TiO2 with KH550 was envisioned to improve dispersion in the Polyvinylidene fluoride (PVDF) matrix, where CO2 molecules must travel a more tortuous path, a phenomenon known as the distortion effect. PVDF/N‐TiO2 composites showed better CO2 barrier properties. The permeability coefficient of PVDF/0.5% N‐TiO2 is 18.30% lower than primary PVDF. Nanoparticles can act as a barrier to gas penetration in the polymer matrix. However, the agglomeration of nanoparticles has a negative effect on the comprehensive properties of nanocomposites. We envisioned surface modification of 25 nm TiO2 nanoparticles with KH550 to enable better dispersion in the polyvinylidene fluoride (PVDF) matrix and prepared PVDF/TiO2 composites by the melt blending method. The effects of adding modified nanoparticles into the matrix on the thermodynamic, mechanical, rheological, and gas barrier properties were studied. We find that the dispersion of TiO2 in the matrix significantly improved after modification, as observed in the SEM images. As a result, the mechanical properties of composites decreased with an increase in the content of nanoparticles, and PVDF/N‐TiO2 composites showed better mechanical and CO2 barrier properties. The permeability coefficient of PVDF/0.5% N‐TiO2 has the lowest permeability coefficient, which is 18.30% lower than primary PVDF. At a high shear rate, the viscosity of PVDF/N‐TiO2 with 0.5% and 1.0% content decreased, and the viscosity of 1.5% ratio was higher than that of primary PVDF. PVDF/0.5% N‐TiO2 has the best comprehensive performance and also possesses the advantages of simple preparation, low cost, and ease of industrial production.
polymer science