Abstract:Ultrafast femtosecond laser systems with hundreds of microjoules of energy operating at repetition frequencies of several kilohertz have very important applications for many fields such as medicine,mid-infrared laser generation,industrial processing and vibrational spectroscopy.The Chirped Pulse Amplification (CPA) technique provides a feasible path to obtain light sources with such parameters.However,the use of chirped pulse amplification increases the technical complexity and cost of the laser system.Recently,the proposal of Multi-pass Cell (MPC) nonlinear pulse compression technique allows us to obtain high power ultrafast femtosecond pulses with reduced technical complexity and cost.The composition of the device requires only two concave mirrors and a nonlinear medium in between.In the past seven years,the Multi-pass Cell nonlinear pulse compression technique has been developed so much that it has become possible to obtain ultrashort pulses with average power of more than a few kW and peak power of tens to hundreds of TW.In this work,we have achieved nonlinear pulse compression for a 100 W picosecond laser using an improved nonlinear pulse compression scheme that combines a hybrid of a plano-cancave multi-pass cell and multi-thin-plate.Using fused silica plates in plano-cancave cavity,the spectral bandwidth (FWHM) of input picosecond laser is broadened from 0.24 nm to 4.8 nm due to self-phase modulation effect,the pulse is compressed to 483 fs by dispersion compensation using grating pairs,which corresponds the compression factor of 22,and the final output power of 44.2 W is obtained.As comparison of conventional MPC,the plano-cancave cavity scheme we developed is a very promising solution for nonlinear compression due to its compact,more stability and large compression ratio.

Few-cycle, mJ-level, mid-wave infrared pulses generated via post-compression of a chirped pulse amplifier

10-µJ-level femtosecond pulse generation in the erbium CPA fiber source with microstructured hollow-core fiber assisted delivery and nonlinear frequency conversion

Laser Chirp Controlled Relativistic Few-Cycle Mid-Infrared Pulse Generation

CEP-Stable, Few-Cycle, kHz OPCPAs for Attosecond Science: Energy Scaling and Coherent Sub-Cycle Pulse Synthesis

High-Contrast Near-Ir Short Pulses Generated by A Mid-Ir Optical Parametric Chirped-Pulse Amplifier with Frequency Doubling

Difference-Frequency Generation of 0.2-Mj 3-Cycle 9-Μm Pulses from Two 1-Khz Multicycle OPCPAs

Studies on nonlinear pulse compression technique based on multi-pass in plano-cancave cavity

Microjoule Level Femtosecond Optical Pulses with Double-Cladding Fiber-Based Nonlinear Chirped-Pulse Amplification

2.6mJ/100Hz CEP stable near-single-cycle 4μm laser based on OPCPA and hollow-core-fiber compression

Post-compression of multi-mJ picosecond pulses to few-cycles approaching the terawatt regime

112-Μj 180-Fs Pulses at 1-Khz Repetition Rate from Yb-Doped Laser Based on Strictly All-Fiber CPA Structure

High-power 0.4-mJ picosecond CPA system based on an extra-large-mode-area triple-clad fiber

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

Mid-infrared pulse generation via achromatic quasi-phase-matched OPCPA

Generation of 3 mJ, 44 fs, 2.5 micrometer pulses from a single-stage Cr2+:ZnSe amplifier

High-Energy, Few-Cycle, Khz Opcpa At 2.1 Mu M Pumped By A Picosecond Cryogenic Yb:Yag Laser

A Pulse Compressor for A Chirped-Pulse Amplification System Based on A Frequency-Doubling Crystal and Grating

High-energy, Few-cycle, Khz OPCPA at 2.1 Μm Pumped by a Picosecond Cryogenic Yb:YAG Laser

High-power chirped pulse amplification based on Yb-doped rod-type PCF and nonlinear amplifying loop mirror oscillator

Generation of 18-Fs, Multiterawatt Pulses by Regenerative Pulse Shaping and Chirped-Pulse Amplification

High-repetition-rate femtosecond mid-infrared pulses generated by nonlinear optical modulation of continuous-wave QCLs and ICLs