Abstract:This work reports an experimental and kinetic modeling investigation on flame chemistry of propene at elevated pressures. The chemical structures of premixed propene/O2/Ar flames at 2–5 atm and the equivalence ratio of 1.5 including reactants, major products and a series of intermediates were measured using the flame sampling molecular beam mass spectrometry. The maximum mole fractions of H, CH3 and C2H6 decrease with increasing pressure, while that of CH4 follows the opposite trend. Laminar burning velocities (LBVs) of propene/air mixtures at equivalence ratios of 0.7–1.5 and initial pressures up to 10 atm were measured using the spherically propagating flame method. Remarkable pressure effects can be observed, especially under the lean and rich conditions. A kinetic model for propene combustion was developed based on our recent model for ethylene combustion and recently reported chemically termolecular reactions and HCO prompt dissociation reactions. Key reactions in the propene flames were revealed using the modeling analysis, especially for those playing significant roles in the pressure effects. Two chain termination reactions including the self-combination of CH3 and the recombination between CH3 and H are found to be crucial for the observed pressure effects in maximum mole fractions of H, CH3, CH4 and C2H6. The HCO prompt dissociation can significantly promote the laminar flame propagation of propene/air mixtures due to the substantial formation of CH2O through CH2+O2 and CH3+O pathways, while the chemically termolecular reactions exhibit weak inhibition effects at equivalence ratios smaller than 1.2. The reason for the stronger pressure effects of LBVs under the lean and rich conditions is that the excess O2 and abundantly produced CH3 enhances the roles of H+O2(+M)=HO2(+M) and CH4(+M)=CH3+H(+M) in chain termination, respectively.

Flame Propagation Characteristics of Hybrid Explosion of Ethylene and Polyethylene Mixture under Pressure Accumulation

Effects of volatile organic compounds on the explosion characteristics of polyethylene dust

Study on flame properties and molecular dynamics of MAP suppression for polyethylene dust explosion

Investigation of the Effects of Hydrogen Addition on Explosion Characteristics and Pressure Fluctuations of Ethyl Acetate

Effect of hydrogen addition on explosion characteristics of premixed methane/air mixture under different equivalence ratio distributions

The explosion enhancement of methane-air mixtures by ethylene in a confined chamber

The effects of different equivalence ratios and initial pressures on the explosion of methane/air premixed gas in closed space

Investigation on the effect of carbon powder structural characteristics derived from ethylene decomposition on powder explosion

Laminar burning Velocities, Markstein numbers and cellular instability of spherically propagation Ethane/Hydrogen/Air premixed flames at elevated pressures

Revisit Flame Chemistry of Propene at Elevated Pressures: Insight into Pressure Effects on Chemical Structure and Laminar Flame Propagation

Experimental Study on the Explosion and Flame Emission Behaviors of Methane-Ethylene-air Mixtures

Explosion of gaseous ethylene-air mixtures in closed cylindrical vessels with central ignition

Influence of equivalence ratio and H 2 blended ratio on explosion propagation characteristics of DME/H 2 blended gas in closed narrow space

Numerical Simulation of Flame Acceleration and Deflagration-To-Detonation Transition of Ethylene in Channels

Flame propagation and counterflow nonpremixed ignition of mixtures of methane and ethylene

Inerting effect of N2 on explosion of LDPE dust/ethylene hybrid mixtures

Experimental Study on Explosion Characteristics of Ethanol-Gasoline Blended Fuels

Evaluation of hydrogen-blended methane explosion

Influence of pressure on the flammability limits and explosion pressure of ethane/propane-air mixtures in a cylinder vessel

The Explosion Characteristics of Methane, Hydrogen and Their Mixtures: A Computational Study

Prediction of the explosion severity of hybrid mixtures