Influence of pressure on the flammability limits and explosion pressure of ethane/propane-air mixtures in a cylinder vessel

Lijuan Huang,Yu Wang,Liang Zhang,Yuliang Su,Zhe Zhang,Shaoran Ren
DOI: https://doi.org/10.1016/j.jlp.2021.104638
IF: 3.916
2022-01-01
Journal of Loss Prevention in the Process Industries
Abstract:To comprehensively investigate the pressure influence on the flammability limits and explosion pressure of ethane and propane, a high-pressure slender cylindrical vessel with an effective length and diameter of 36.2 cm and 5 cm was used to simulate the explosions occurring in tubing-like space. Coiled tungsten hotwires with high-ignition energy were used as the ignition source during end-wall ignition. The lower flammability limit was assessed for ethane and propane under high pressures up to 15 MPa. A logarithmic dependence of pressure on flammability limits was observed in the examined pressure range. Comparing the lower alkanes data revealed that with rising carbon numbers, the lower flammability limit reduced. The impact of initial pressure on the upper flammability limit of ethane and propane was carried out below 5 MPa and 2.5 MPa, considering the liquefaction of ethane and propane under elevated pressures. For evaluating UEL data for C2H6/C3H8 in the air at high pressure, algebraic equations were developed. Due to the higher combustion heat and adiabatic flame temperature of C2H6 and C3H8, the explosion pressure of them was higher than that of CH4, and propane produced the highest explosion pressure. The explosion pressure varied approximately linearly with the initial pressure. Because of the low concentration of combustible gas at the lower flammability limit, the explosion pressure was lower than that at the upper flammability limit. The underlying mechanism for the pressure dependence of the LFL is correlated to the combustion heat.
engineering, chemical
What problem does this paper attempt to address?