Abstract:Aluminium nitride (AlN) is one of the materials used for the preparation of substrates for electronic circuits. Such substrates can be prepared via tape casting method. Until now, only non-aqueous and aqueous tape casting was developed and studied for AlN. In this work, the development of UV-curable tape casting for AlN, including the use of photopolymerisable binder, is shown. Two different dispersing agents, BYK-W 9010 and glycerol trioleate, were used to stabilize and homogenize AlN dispersions. In order to modify the powder surface, a pre-treatment step was used, where the powder was first mixed with the dispersing agent in an azeotropic solvent mixture, followed by the evaporation of the solvents and the redispersing of the pre-conditioned powder into the reactive binder. The effective concentration of the dispersants, the impact of the solid loading on the viscosity and slurry behaviour, as well as the effect of the powder pre-conditioning, were studied by means of rheological measurements. Green tapes were optimised by evaluating the effect of the casting gap and the photo- and co-initiator concentrations. Finally, FTIR measurements were used to estimate the polymer conversion degree as a function of exposure time for the green tapes.

Colloidal processing and characterization of TiO 2 –MnO‐doped alumina/alumina slurries and tapes

Aqueous Tape Casting and Mechanical Properties of La2NiO4+δ Dense Membranes

Optimization of the Tape Casting Process for Development of High Performance Alumina Ceramics

Preparation and microwave dielectric properties of multilayer Li 1.075 Nb 0.625 Ti 0.45 O 3 co-fired ceramics with aqueous tape casting

Processing of Al2O3 sheets by the gel–tape-casting process

Fabrication and characterization of Li1+x-yNb1-x-3yTix+4yO3 substrates using aqueous tape casting process

Aqueous processing of Li1.075Nb0.625Ti0.45O3 green tapes

Aqueous Tape Casting of Li1.075Nb0.625Ti0.45O3 Microwave Ceramic Sheets

Gel-Tape-Casting Of Ceramic Substrates

Tape Casting of Ba0.7sr0.3tio3 for Tunable Microwave Devices

Rapid fabrication of extremely thin Nano-Al2O3 transparent ceramic wafers through nonaqueous tape casting

The Study of the Tape Casting Processing's Influence on the Templates

Tape Casting of Ba<sub>0.7</sub>Sr<sub>0.3</sub>TiO<sub>3</sub> for Tunable Microwave Devices

Optimization Of Non-Aqueous Tape Casting Of High Solid Loading Slurry For Aluminum Nitride Ceramic Substrates

Aqueous tape casting of Li1.075Nb1.625Ti0.45O3 using PVA/PVAc co-binder

Effects of Zro_2 Powder Characteristics and Organic Additives on Preparation of Tape Casting Film

Study on the Fabrication of Porous TiAl Alloy Via Non-Aqueous Gel Casting of a TiH2 and Al Powder Mixture

Influence of the Slip Composition on the Properties of Tape-cast Li_(1.075)Nb_(0.625)Ti_(0.45)O_3 Aqueous Slurry

Preparation Of Green Tapes For Ltcc/Cu Multilayer Substrates

Tape casting of UV-curable aluminium nitride-based slurries