Abstract:Using granulated blast furnace slag (GGBS) as the volcanic ash material and fly ash (FA) as the supplementary material, the study was conducted to investigate the mix proportions of an alkali-activated solid waste cementitious material under the stimulating effect of alkali activator carbide slag (CS). This type of cementitious material could serve as a substitute for a portion of cement usage, contributing to resource conservation and mitigating environmental pollution caused by solid waste. This facilitates green and sustainable development. Firstly, an analysis of three raw materials was conducted, and the mix proportions were designed with reference to the CaO-Al 2 O 3 -SiO 2 system of Portland cement. Then 28 groups of specimens were prepared based on the designed mix proportions. The flowability and setting time of each group of specimens were tested. It was observed that an increase in the amount of CS and a decrease in the amount of GGBS resulted in decreased flowability and earlier setting times of the specimens. Additionally, FA exhibited a retarding effect on setting time. Compressive strength tests were conducted on these specimens, revealing that the optimal CS content ranged between 20 % and 40 %. Overall, FA had minimal impact on compressive strength, but it contributed to increased compressive strength in the specimens at later ages. Subsequently, microscopic characterization of the hydration products was performed using X-ray Diffraction (XRD), Fourier Transform Infrared (FTIR), Differential Thermal Analysis (DTA), Scanning Electron Microscope (SEM), and Energy Dispersive Spectrometer (EDS). The hydration products were identified as predominantly composed of calcium silicate hydrate. The quality and defects in the microstructure of gel products from various specimen formulations were compared to elucidate differences in macroscopic performance. Finally, the hydration process mechanism diagram of alkali-activated materials was presented to illustrate the stimulation and formation of gel products, primarily composed of C-S-H. This diagram revealed the principles behind the action of alkali-activated cementitious materials. The proposed design and testing methodology for the GGBS-FA-CS system in this study had certain reference significance for research in the direction of alkali-activated solid waste cementitious materials.

Preparation of concrete from vitrified slag: process parameter optimization and characterization

Effects on the Concrete Properties of That, the Natural Sand in Concrete is Replaced by the Blast Furnace Slag

Experimental study on strength and abrasion-resistance enhancement admixture

Influence of Steel Slag on Mechanical Properties and Durability of Concrete

Test and Microstructural Analysis of a Steel Slag Cement-Based Material Using the Response Surface Method

Influences of Ultrafine Slag Slurry Prepared by Wet Ball Milling on the Properties of Concrete

Modification of ultrafine blast furnace slag with steel slag as a novel high-quality mineral admixture to prepare high-strength concrete

Mechanical properties and durability of concrete modified with steel slag and silica fume

Effect of fillers on the mechanical properties and durability of steel slag concrete

Experimental Study Based on Box–Behnken Design and Response Surface Methodology for Optimization Proportioning of Activated Lithium Slag Composite Cement-Based Cementitious Materials

Steel Slag Accelerated Carbonation Curing for High-Carbonation Precast Concrete Development

Research on Mechanical and Shrinkage Characteristics of a Resource-Based Cement Solid-Waste Concrete

Technical and environmental assessment of sludge-derived slag generated from high temperature slagging co-gasification process as a sustainable construction material

Experimental Study on High-performance Lithium Slag Concrete

Experimental Research on the Performance of Recycled Waste Concrete Powder (RWCP) on Concrete

Influence of Steel Slag Powder on Compressive Strength and Durability of Concrete

Study on Preparation and Interfacial Transition Zone Microstructure of Red Mud-Yellow Phosphorus Slag-Cement Concrete

Characterization and Performance of High Volume Recycled Waste Glass and Ground Granulated Blast Furnace Slag or Fly Ash Blended Mortars

Analysis of Slag-Containing Steamed Concrete's Composition Efficiency

Optimization design of low-carbon hybrid concrete containing slag and limestone powder

Study on the preparation, performance, and mechanism for solid waste cementitious materials